Viking VDD5450SS Utilizzo E Cura
4
PLAN THE WIRING
1. This downdraft blower using the Flex Blower (purchase
separately) draws 3.0 Amps and requires a 120 VAC, 60 Hz
circuit. If using a remote blower (purchase separately), the
system draws 6.0 Amps (max.) and requires a 120 VAC, 60
Hz circuit.
circuit. If using a remote blower (purchase separately), the
system draws 6.0 Amps (max.) and requires a 120 VAC, 60
Hz circuit.
2. The unit has a 18 in. long power cord with a 3-pronged plug.
Plan to provide a grounded outlet in a location which will
allow the unit’s power cord to reach.
allow the unit’s power cord to reach.
3. Install electrical box according to local codes.
PREPARE THE DOWNDRAFT
Installations ducting through front panel opening only:
1. Place the downdraft on its back on a table or fl at work surface.
2. Loosen
the
HEX NUTS on the CLAMP CHANNEL and remove
the FRONT PANEL COVER.
FRONT PANEL COVER
CLAMP
CHANNEL
(4-6) HEX
NUTS
Installations using FLEX BLOWER only:
(Purchase Model VDVI600 Flex Blower separately.)
3. Determine its location on FRONT PANEL and whether it will
discharge to the left, right, or down.
Use a combination of COVER PLATES (3" and/or 6" wide) to
close the opening on side(s) of blower.
close the opening on side(s) of blower.
Slide the blower and cover plates between the LOWER
CHANNEL and the clamp channel. Tighten the hex nuts to
secure blower and panels in place.
secure blower and panels in place.
LOWER
CHANNEL
COVER
PLATE
COVER
PLATES
FLEX
BLOWER
FRONT
PANEL
If blower
discharge is
down,
electrical
panel must be relocated.
See Step 6.
PLAN CABINET CUTOUTS
!
CAUTION:
BEFORE CUTTING HOLE IN CABINET FOR
DUCTWORK, check for interference with fl oor
joists, wall studs, electrical wiring, or plumbing.
Use the dimensions in the above illustration to help plan how and
where to provide duct access through your cabinet. Generally, 2"
x 19" rectangular duct will be used through left, right, and back of
cabinet - while 8" round duct will be used through cabinet fl oor.
where to provide duct access through your cabinet. Generally, 2"
x 19" rectangular duct will be used through left, right, and back of
cabinet - while 8" round duct will be used through cabinet fl oor.
INSTALLATION
CENTER LINE
HOLE FOR 8” or
10” ROUND DUCT
(*Adjustable 6” Left and 6” Right)
(When using Remote Discharge Plate - Hole is
adjustable 6” Left and 6” Right from
Installation Center Line.)
HOLE
FOR
2” X 19¼”
DUCT
INSIDE
CABINET BACK
INSIDE
CABINET
FLOOR
1½”
6” *
6” *
19¼” centered
2”
26¾”
6 ”
/
8
7
1 ”
/
8
7
19¼”
2”
Electrical panel
can be mounted
remotely.