Marvel ML24WSF3LP Manuale Utente

6

1) Decide where you want to place the wine cellar. Slide it 

into place, being careful not to damage the floor, leaving 1" 

(2.5 cm) of clearance from the rear wall to allow room for 

the anti-tip bracket.

 

2) Raise the rear leveling legs approximately 

1

⁄

4

" (6 mm) to 

allow engagement with the anti-tip bracket. Level the unit 

by adjusting all the leveling legs as required. Turning the 

leveling leg counterclockwise will raise the unit and clock-

wise will lower the unit.

3) Make sure the wine cellar is in the desired location, then 

mark on the floor the rear and side corner of the cabinet

where the anti-tip bracket will be installed. If the installation

does not allow marking the rear corner of the cabinet, then

make temporary lines on the floor marking the front corner 

of the cabinet, excluding the door. Slide the wine cellar out 

of the way. From the temporary line extend the sidewall 

line back 21

1

⁄

2

" (54.6 cm) as shown in Figure 6. 

4) Align the anti-tip bracket to the marks on the floor so 

the side of the bracket lines up with the side of the cabinet 

mark, and the "V" notches on the anti-tip bracket line up 

with the end of the 21

1

⁄

2

" (54.6 cm) line (Rear of cabinet 

line).

5) Fasten the anti-tip bracket to the floor using the supplied 

screw. (See Figure 6).

6) Slide the cabinet back into position, making sure the 

rear cabinet leveling leg slides under the anti-tip bracket 

engaging the slot.

Front of cabinet

Figure 5

21

1

⁄

2

"

(54.6 cm)

Anti-Tip

Bracket

Leveling Leg

Bottom View of

Wine Cellar 

If your wine cellar is not located under a counter top (free 

standing), you must use an anti-tip device installed as per 

these instructions. If the wine cellar is removed from  its lo-

cation for any reason, make sure that the device is properly 

engaged when you push the wine cellar back into the origi-

nal location. If the device is not properly engaged, there is 

a risk of the wine cellar tipping over, with the potential for 

property damage or personal injury. 

If installing on a concrete floor, concrete fasteners are 

required, (not included with the anti-tip kit).

Any finished flooring should be protected with appropriate 

material to avoid damage when moving the unit.

The anti-tip bracket is to be located on the floor in the left or 

right rear corner of the wine cellar as shown in Figure 5.

•  ALL APPLIANCES CAN TIP 

RESULTING IN INJURY.

•  INSTALL THE ANTI-TIP 

BRACKET PACKED WITH 

THE APPLIANCE.

•  FOLLOW THE INSTRUC-

TIONS BELOW