Marvel ML24WSG2RS Manuale Utente

12

The temperature mode is preset from the factory in Fahren-

heit (°F) but you have the option to change it to Centigrade 

(°C). To change the mode, press and hold the "-" keypad, 

while pressing the "+" keypad, then release the "-" keypad.

The temperature will now be displayed in Centigrade (°C).

Repeat the procedure to change the temperature mode 

back to Fahrenheit (°F).

If power to the appliance is inter-

rupted the System Status indicator will turn-off and 

the "Power Failure" indicator will flash. Additionally, an 

"ALARM RESET" indicator will be displayed below the 

"On/Off" keypad. No audible tone will sound. This alarm 

condition can be reset by momentarily pressing the 

"On/Off" keypad. If this alarm occurs, it is recommend-

ed that you check the condition of any perishables, 

even if the appliance is operating normally and the tem-

perature has recovered, as prolonged power outages 

could result in excessive temperature excursions which 

may spoil perishables.

If the storage compartment 

temperature exceeds 10°F from set-point for more than 

a 1-hour duration, the System Status indicator will turn 

off, the "Temp" indicator will flash, and an audible tone 

will sound every 60-seconds. Additionally, an "ALARM 

RESET" indicator will be displayed below the "On/Off" 

keypad. This alarm condition can be reset by momen-

tarily pressing the "On/Off" keypad. If this alarm occurs 

it is recommended that you check the condition of your 

stored contents, even though the appliance is operating 

normally and the temperature has recovered, as pro-

longed temperature excursions could spoil perishables.

Multiple alarms are possible, i.e.- "Door Ajar" for a pro-

longed period may trigger a "Temp" alarm, in which case 

both "Door Ajar" and "Temp" indicators will activate.

The control panel can be locked to avoid unintentional 

changes. To lock the control, press and hold the "Lock" key-

pad until the display reads "Loc" then release your finger 

from the keypad. The lock icon will flash 3-times and then 

continuously illuminate. When the control panel is locked, 

only the Lock keypad, System Status OK indicator , and 

the Alarm indicator are active. To un-lock the control panel, 

repeat this instruction until the display reads "nLc".

The control will alert you to conditions that could adversely 

affect the performance of the appliance.

•  Door ajar - 

If the door is open, or not closed prop-

erly, for more than 5-minutes the System Status OK 

indicator will turn-off, the "Door Ajar" indicator will flash, 

and a tone will sound every 60 seconds. Additionally, 

an "ALARM RESET" indicator will be displayed below 

the "On/Off" keypad. This alarm condition can be reset 

by closing the door or momentarily pressing the "On/

Off" keypad, (i.e.-if you are cleaning the storage com-

partment, etc.). The alarm will recur in 5-minutes if the 

alarm condition persists.