Marvel MP15WSF3LP Manuale Proprietario

12

Use extreme caution with the articulated hinges. The 

hinge is self closing and many pinch points exist prior 

to built-in installation. 

Loosen (do not remove ) these 

2 phillips head screws on the 

top and bottom hinges

If you purchased an overlay panel model, your unit is 

equipped with articulated hinges to allow fully integrated 

built-in installations. Custom panel thicknesses of 

5

⁄

8

" (15 

mm) and 

3

⁄

4

" (18 mm) are accommodated.

It is important to use the factory provided grille that came 

with the product to assure proper air flow is maintained 

through the condenser. The use of a custom grille is not 

recommended and will void the warranty.

Figure 8

Figure 8b

Bottom of

door

Figure 8a

"P" clamp 

and screw

Wire connector

see Figure 9

Cabinet 

"Z" Bracket

Overlay panel models are designed for use with 

in installations only. Use in freestanding installations 

could result in personal injury.

With a phillips screwdriver remove the screw and "P" clamp 

from the bottom of the door near the hinge. See Figure 8b.

Disconnect the door wire harness by pressing and holding 

down the locking tab on the wire connector and pulling the 

connector apart. See Figure 9.

Open the door and loosen the screws holding the hinges to 

the cabinet (2 at the top and 2 at the bottom hinge). Do not 

remove the screws but loosen them enough so the hinges 

can be slipped off of the screws when sliding the door to 

the side.

With a helper, and being careful not to scratch the cabinet 

or the door, slide the door to the side about 

1

⁄

2

 inch and 

remove the hinges and door from the unit.

The articulated hinges have many pinch points. Care-

fully close / collapse the hinges as soon as the door is 

removed from the cabinet.