Marvel MP15WSF3LP Manuale Proprietario

16

Counter bore 

lock hole

on back side.

Figure 19a

#10 x 

1

⁄

2

"

screw

Figure 19

Hinge side of door

1

⁄

2

" (13 mm) diameter 

drill through door panel, 

from other side (see 

detail above) 

13

⁄

16

" 

(20.5 mm) counter bore, 

7

⁄

16

" (11 mm) deep.

17

⁄

32

"

(13.7 mm)

3

1

⁄

2

"

(89 mm)

Two (2) lock extensions are provided with the lock. Use the 

longer extension for 

3

⁄

4

" thick overlay panels and the shorter 

one for 

5

⁄

8

" thick overlay panels. Assemble the lock exten-

sion, cam stop washer, spring washer, and set screw to the 

lock as shown in Figure 20 and 21.

Install this lock assembly into the lock hole in the overlay 

panel and secure with the retaining nut on the back side 

with a 15 mm socket and ratchet. Make sure the key slot in 

the front of the lock is vertical.

Attach the lock cam to the back of the lock assembly with 

the phillips head screw provided. Orient the lock cam verti-

cally when installing on the lock.

The preferred method of attaching the panel to the door 

is to clamp the panel to the door so it cannot move while 

drilling the screw pilot holes. Use bar clamps or "C" clamps 

with pads on the clamping surfaces that will not mar the 

panel or the door. The custom overlay panel should be 

flush with the top of the door and centered along the width 

of the door. See Figure 10a. Drill holes through the gasket 

extrusion using the 10 holes as pilot holes. Use the drill 

size from the chart in Table "C", being careful not to drill 

through the front surface of the panel, drill no deeper than 

1

⁄

2

" (12.7 mm) deep. If the overlay panel is thinner than 

5

⁄

8

" (16 mm) thick shorter screws will have to be obtained. 

Fasten the panel to the door with the 10 screws provided in 

the literature pack. (See Figure 19a). Remove the clamps 

and replace the gasket in the gasket extrusion channels of 

the door. Some force may be required to seat the gasket 

into the channels. Be sure the gasket corners are seated 

properly.

Hardwood

1

⁄

8

" (3.2 mm) Diameter. Pilot Hole

Softwood

7

⁄

64

 (2.8 mm) Diameter. Pilot Hole

Table C