Whirlpool XHPC155YBD Istruzione Sull'Installazione

 Position the pedestal toward the front of the dryer and install  

the two remaining hex-head sheet metal screws. Do not tighten  

completely. Now proceed to “Complete the pedestal installation”.

 Position the pedestal toward the front of the washer and  

install the two remaining hex-head sheet metal screws.  

Do not tighten completely. Now proceed to “Complete  

the pedestal installation”.

Partially install two of the #12 x 3/4" hex-head sheet metal 

screws in the indicated holes. Leave a space of about 3/8"  

(10 mm) between the screw head and the bottom of the dryer.
note: If your dryer has leveling feet installed, remove them. 

Do not install the feet that came with the new dryer.

Move the pedestal against the dryer bottom. The front of  

the pedestal cabinet should align with the dryer cabinet  

as shown below. 
Slide the pedestal’s keyhole slots over the lower two partially 

installed screws.

To avoid floor damage and ease installation and handling,  

unfold the empty pedestal box flat and place it next to the dryer. 

Position the drawer divider so that it will be near the top of the 

dryer, as shown. Gently tip the dryer on its side so the dryer is 

resting on the drawer divider.