Viking VEWD527GG Manuale
17
16
Operation
Operation
Food
Temperature
Settings
Moisture
Settings
Bacon
2 – 3
–
Beef, medium
and well done
and well done
2
+
Beef, rare
1 – 2
+
Bread, hard roll
2
–
Bread, soft rolls
2
–
Casseroles
2
+
Cooked cereal
2
+
Dough, proofing
1
+
Eggs
2
+
Fish, seafood
(baked)
(baked)
2
+
Fried foods
3
–
Fruit
2
+
Gravy, creamed
sauces
sauces
2
+
Ham
2
+
Pancakes, waffles
2 – 3
+
Pies, one crust
2
+
Pies, two crust
2
–
Pizza
2 – 3
halfway
Pork
2
+
Potatoes, baked
3
halfway
Potatoes, mashed
2
+
Poultry
2 – 3
+
Vegetables
2
–
Suggested Heat Settings
The information below is given as a guide only. You may need to vary
the heat settings to suit your personal requirements.
the heat settings to suit your personal requirements.
Cleaning and Maintenance
Pr
oduct Car
e
Any piece of equipment works better and lasts longer when
maintained properly and kept clean. Cooking equipment is no
exception. Your warming drawer must be kept clean and maintained
properly. Make sure all controls are in the “OFF” position.
maintained properly and kept clean. Cooking equipment is no
exception. Your warming drawer must be kept clean and maintained
properly. Make sure all controls are in the “OFF” position.
1. Allow warming drawer to cool completely.
2. It is important to keep the slide rails clear and free from debris.
Periodic cleaning of slide rails and other adjoining parts is
necessary to assure smooth drawer operation.
necessary to assure smooth drawer operation.
3. If needed, the warming drawer pan support can be removed for
cleaning. Pull the warming drawer out until fully extended. Slide
finger along right and left side rail until you reach hand latches
(located at the front of rails). Pull up on both right and left latches.
Pull drawer support completely out.
finger along right and left side rail until you reach hand latches
(located at the front of rails). Pull up on both right and left latches.
Pull drawer support completely out.
4. When installed outdoors, annually inspect the silicon seal around
the flange of the appliance. Re-seal as needed to assure this seam
is waterproof.
is waterproof.
Control Knobs
MAKE SURE ALL CONTROL KNOBS POINT TO THE “OFF” POSITION
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Dry completely and replace by pushing firmly onto stem.
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Dry completely and replace by pushing firmly onto stem.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot soapy
water at the end of each cooling period and with a liquid cleaner
designed for that material when soapy water will not do the job. DO
NOT use steel wool, abrasive cloths, cleansers, or powders. If necessary,
scrape stainless steel to remove encrusted materials, soak the area with
hot towels to loosen the material, then use a wooden or nylon spatula or
scraper. DO NOT use a metal knife, spatula, or any other metal tool to
scrape stainless steel. DO NOT permit citrus or tomato juice to remain
on stainless steel surface, as citric acid will permanently discolor stainless
steel. Wipe up any spills immediately.
water at the end of each cooling period and with a liquid cleaner
designed for that material when soapy water will not do the job. DO
NOT use steel wool, abrasive cloths, cleansers, or powders. If necessary,
scrape stainless steel to remove encrusted materials, soak the area with
hot towels to loosen the material, then use a wooden or nylon spatula or
scraper. DO NOT use a metal knife, spatula, or any other metal tool to
scrape stainless steel. DO NOT permit citrus or tomato juice to remain
on stainless steel surface, as citric acid will permanently discolor stainless
steel. Wipe up any spills immediately.