CRU DataPort Dual Port 25 SAS 8530-7202-9500 Dépliant

1 - DataPort 25 SAS frame assembly 
1 - DataPort 25 SAS carrier assembly 
4 -  M3 x 4mm Phillips pan-head screws for hard drive mounting 

4 -  M3 x 5mm Phillips pan-head screws for frame mounting with 

rails 

4 -  M3 x 4mm Phillips pan-head screws for frame mounting in 

case 

2 -  M3 x 4mm Phillips pan-head screws for carrier cover mounting 
2 - Keys for lock

1. Locate an available external 3.5” drive bay and remove the front bezel.

2. To mount the frame assembly in the drive bay:

a.   Check the drive bay to see if mounting rails are required (they 

should be provided by your computer system manufacturer.) If 
required, install one on each side of the frame. Then slide the 
frame in the computer and check that it is secure.

b.   If mounting rails are not required, attach the frame directly to 

the PC case using the screws provided.  Either the side or bot-
tom mount holes on the frame may be used.

The Activity LED is normally on when the hard disk drive is ready 
and will flash during drive activity.

3.  Locate and connect an available 4-pin power connector (the type used 

for floppy drives) to the back of the DataPort 25 frame.  For SAS drive 
operation, 12 volt power is required.

4.  Connect the data cables to the rear of the frame. See Operations sec-

tion for details on proper cabling. 

Your frame assembly is complete.

1.   Remove the two screws that hold the cover and slide the cover off. 

Note: Do NOT use screws longer than those supplied as the hard 
disk drive will be damaged.

2.  Connect the hard drive to the connector on the circuit board. Use the 

provided screws to secure the hard drive.

Note: The DataPort 25 dual port carrier supports SAS, SATA and 
SATA Flash drives up to 15.4 mm in height.

Figure 1: Back of Frame

The DataPort 25 Dual Port SAS is a high-performance small form factor 
enclosure designed to make any capacity 2.5” SAS or SATA HDD removable 
from a 3.5” peripheral bay.  SAS provides the highest levels of performance and 
reliability.  The DataPort 25 Dual Port SAS can support Dual Port SAS operation 
with a SAS drive.  The DataPort 25 Dual Port SAS can also support a single 
SATA drive or when used with the DataPort 25 dual drive SATA carrier, two 
SATA drives.

SAS/SATA 

Port 2

SAS/SATA 

Port 1

Power Connector

JP9

JP 7