CRU DataPort LP, Serial ATA 3Gb/s 8250-5000-9500 Dépliant

1 - DataPort LP SAS/SATA Carrier
1 - DataPort LP SAS/SATA Frame
4 - 6 x 32 x 3/8” flat-head screws for hard drive mounting
4 - M3 x 10mm Phillips pan-head screws for frame mounting

To install the DataPort LP, remove the carrier from the frame. To 
remove the carrier, press the release button on the left corner 
of the carrier. This will release the ejection lever to remove the 
carrier (see figure 1). Extend the ejection lever fully to release the 
carrier. Use the lever to pull the carrier out of the frame. 

1.  Slide the frame into the enclosure and, using the screw holes 

provided, secure the frame into the enclosure. For installations 
requiring mounting rails, attach the mounting rails and then 
slide the frame into the enclosure. 

2.  Connect the data cable and the power cable to the back of 

the frame.  For SATA support connect the HBA to JP4. For SAS 
support use JP5 or JP4 (see figure #2). For dual host support 
each data connector must be connected to a different host. 

1.  Slide the SAS or SATA hard drive into the carrier and secure it 

with the provided screws.

 
2.  Make sure the lever is fully extended before inserting the 

carrier into the frame. Insert the carrier and then close the 
lever by pushing it back in to complete the insertion and secure 
the carrier. Power up the enclosure; the drive should spin up 
and be operational. The green LED indicates that the drive is 
powered up and the amber LED indicates drive activity. 

Figure 1: Front View

The DataPort LP is designed to mount via top, bottom, or 

side mounts. This allows the maximum number of options 

to mount the DataPort LP into any enclosure.

release 

button