Marvel M24DZBGPL Istruzione Sull'Installazione

24

Defrosting is automatic. It takes place in the Power Module, 

above and away from your food. For several minutes each 

day the compressor and interior fan will shut off, while any 

ice accumulation is removed from the coils.

It’s easy to keep your Built-In wine cellar clean.  Occasion-

ally, clean the interior walls, shelves, door interiors and 

gaskets with a solution of two (2) teaspoons of baking soda 

dissolved in a quart of lukewarm water. Harsh abrasives 

and cleaning powders are unnecessary and should never 

be used. Do not place parts in the dishwasher.

It is recommended that circuit breakers be shut off before 

cleaning. Wring excess moisture from sponge or cloth and 

avoid excess moisture, especially when cleaning in the 

vicinity of switches, lights or controls.

If your unit has a stainless steel interior, shelves or exterior 

door then use a stainless steel cleaner and a cloth to clean.

The condenser is located behind the top grille. It is a part 

of the Power Module on its very right hand side. It has 

horizontal tubes with small diameter vertical wires and it is 

black in color. It is away from floor dust, however, 

essary. Remember to shut off the circuit breaker before 

removing the grille and before exposing, cleaning, and/or 

vacuuming the condenser.

Figure 28

-Condenser

(behind grille)

Power module

(on top of cabinet)-

The louvered black or stainless steel grille is all one assem-

bly. There are 3 ways to remove the grille. The most widely 

used method of mounting is with springs. The spring(s) are 

located behind the grille back. The spring(s) are mounted 

to the top of the cabinet and hook to the square holes in the 

grille back. To remove the grille, pull the grille forward and 

reach down to the spring and unhook it from the grille back. 

The grille back will be free to be removed.

The second method (optional) is with mounting brackets 

behind the grille back. Pull the grille forward about one (1) 

inch to expose the top screw in the brackets. Unscrew the 

screw to loosen it but do not remove it. Do this to each 

bracket. CAUTION, when the screw is loosened, the grille 

back will be loose, do not allow it to fall. Grasp the grille 

back on each side and tilt the top forward and lift upward to 

free the grille from its mounting.

A custom panel grille can be removed by lifting up on the 

facia panel and pulling forward on the facia panel. The grille 

back is held in place by a screw at the center going up into 

the adjacent cabinet. Remove this screw and the grille back 

can be removed.

The louvered grille is heavy so use care when removing.  

Now you can inspect the condenser for dust accumulation.

Be sure to refasten top grille after cleaning to avoid injury, 

as grille could fall if not properly fastened.