CRU DE200, SCSI Carrier 6177-1400-0000 Dépliant

1.  Locate the ID select jumper positions on the drive, and remove any 

jumper plugs installed (the drive carrier board will plug into this sec-
tion of the drive).

2.  Carefully insert the drive into the carrier. Slide the drive towards the 

drive carrier board, so that the I/O, DC power, and ID select connec-
tors on the drive mate with their respective connectors on the drive 
carrier board.

3.  Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. 

screws (provided).

Remote Unit ID Selection: Pins 1-8 are provided for remote unit ID 
selection for the computer system or expansion chassis. Remote ID 
selection requires that the unit ID switch located on the inside of the 
receiving frame be set to “0” (onboard ID selection is set with a switch 
located on the inside of the receiving frame; see figure 3).

Enable Termination Power Connector (J4): This jumper is installed at the 
factory and enables termination power to/from the SCSI bus.

NOTE: Do not remove this jumper!

Figure 1: Drive Installation Assembly

Notes: For SCSI Ultra320 operation, the DE200 Ultra320 requires 
Ultra320 drives, Ultra320 HBA, and Ultra320-compliant cabling 
(internal and external).

DE200 Ultra320 can support Ultra320 implementations with a 
maximum of fifteen (15) Ultra320 drives (Ultra320 repeater may 
be required).

DE200 Ultra320 receiving frames are indicated by their BLUE LED, 
while the DE200 Ultra320 carriers are indicated by the Ultra320 logo.

Figure 2: Receiving Frame Motherboard (rear view)