CRU DE100, Carrier Only, 68-pin, U160 6507-1000-0000 Dépliant

Factory-Installed Jumpers (J4): There are two (2) jumpers factory-in-

stalled on J4. One jumper is located on Pins 7 & 8, the other on Pins 9 & 10.

NOTE: Do not remove jumpers! (Remove only if attaching the 6103-

1020-0000 Isolator Board.)

Remote Unit ID Selection: Pins 1-8 are provided for remote unit ID selec-

tion for the computer system or expansion chassis. Remote ID selection 

requires that the unit ID select switch located inside the receiving frame be 

set to “0”.

Remote Activity LED: Pins 9 & 10 provide power for a remote LED device 

activity indicator.

Enable Termination Power Connector (W2): A jumper is installed at the 

factory and enables termination power to/from the SCSI bus.

NOTE: Do not remove this jumper!

Note: The DE100 Ultra 160 may be shipped with an isolator/repeater 

board factory-installed. If this is the case, your DE100 Ultra 160 will 

look slightly different from figure above. Please refer to figure below 

for receiving frame with isolator/repeater board attached (rear view).

The DE100 Ultra 160 Isolator/Repeater Board is an upgrade attach-

ment for the DE100 Ultra 160 receiving frame. This attachment pro-

vides both an enhanced, bus-isolating hot swap and repeater function. 

Figure 1: Drive Installation Assembly

Figure 2: Drive Installation Assembly