Liebherr HC20 Istruzione Sull'Installazione

Figure 5

Wall Plate

Figure 6

Wall Plate

Wall

Mounting the anti tipping device

on concrete floors

- Figure 5 - 6

Secure the appliance in place so it does not tip for-

ward when the fully stocked doors are opened. The

anti tipping bracket is provided with the appliance.

1. Mark the center line of the appliance on the back

wall. Align the anti tipping bracket center to this

line.

Be sure that there is no plumbing or

electrical wiring located in this area which

screws or drills could damage.

2. Drill a 3/8" diameter hole in any position as

shown in

Figure 4 using a carbide drill bit.

The depth of the holes must exceed the overall

length of the anchors provided.

Clean the holes after drilling.
3. Attach washer and screw on hex nut to the end

of each anchor.

Drive in all 3 anchors.
Align the bracket center to the center line on the

back wall again.

Fasten the anchors by turning the hex nut.
4. Fasten bracket with 3 screws (1/4" x 2-1/8") into

the wall plate

(Figure 6).

LOCKING

AFETY