Marvel 8SWCEBBGL Istruzione Sull'Installazione

Unit not cold enough.

Adjust temperatures (See 

“Changing Current Settings” 

on page 6).

•  Control set too warm.

•  Content temperature not stabilized.

•  Excessive usage or prolonged door openings.

•  Airflow to front grille blocked.

 

•  Door gasket not sealing properly.

•  Adjust temperature colder. Allow 24 hours 

for temperature to stabilize.

•  Allow temperature to stabilize for at least 24 

hours, with minimal door openings.

•  Airflow must not be obstructed to front 

grille. See “clearances” on page 4.

•  Check door alignment and/or adjust or 

replace door gasket.

Unit too cold.

Adjust temperatures (See 

“Changing Current Settings” 

on page 6).

•  Control set too cold.

•  Door gasket not sealing properly.

•  Adjust temperature warmer. (See page 6, 

“set the desired temperature”). Allow 24 

hours for temperature to stabilize.

•  Check door alignment and/or adjust or 

replace door gasket.

No interior light inside 

cabinet.

•  Bulb burned out.

•  See “Care and Cleaning” page 25 or contact 

a qualified Aga Marvel service representa-

tive.

Light will not go out when 

door is closed.

•  Door not activating light switch.

•  Display light function has been activated. 

(Glass door models only).

•  Verify cabinet is level, refer to page 4 for 

leveling instructions.

•  Verify the door is aligned properly, refer to 

page 19 for instructions.

•  Turn off display lighting.

Noise or Vibration.

•  Unit not level

•  Level unit, see “Leveling Legs” on page 4.

Unit will not run.

•  Unit turned off

•  Power cord not plugged in.

•  No power at outlet.

•  Turn unit on. See “Start your Appliance” on 

page 6.

•  Plug in power cord.

•  Check house circuit.

If the unit appears to be malfunctioning, read through this 

manual first. If the problem persists, check the troubleshooting 

guide below. Locate the problem in the guide and refer to the 

cause and its remedy before calling for service. The problem may 

be something very simple that can be solved without a service 

call. However, it may be required to contact a qualified service 

technician.

                                                     Electrocution Hazard - Never at

                                                     tempt to repair or perform main-

tenance on the unit until the main electrical power has been 

disconnected. Turning the unit control “OFF” does not remove 

electrical power from the units wiring.

•  If the product is within the first year warranty period please 

contact your dealer or call AGA MARVEL Customer Service 

at 800.223.3900 for directions on how to obtain warranty 

coverage in your area.

•  If the product is outside the first year warranty period, AGA 

MARVEL Customer Service can provide recommendations of 

service centers in your area. A listing of authorized service 

centers is also available at www.agamarvel.com under the 

service and support section.

•  In all correspondence regarding service, be sure to give the 

service number, serial number, located on your products se-

rial plate, and proof of purchase.

•  Try to have information or description of nature of the prob-

lem, how long the unit has been running, the room temper-

Date of Purchase

Dealer’s name
Dealer’s Address
Dealer’s City
Dealer’s State
Dealer’s Zip Code
Appliance Serial Number
Appliance Service Number
Date Warranty Card Sent (Must be 

within 10 days of purchase).

26

Table D

ature, and any additional information that may be helpful in 

quickly solving the problem.

•  Table D is provided to document pertinent information 

regarding your product for future reference.