Frigidaire FGGF3058RW Manuale Proprietario

38

• Solutions to common problems

bake or self-clean 

did not start at the 

time expected.

The time of day is incorrect.

Set clock with correct time of day before adding a delay start 

setting. See “Setting the clock” in Setting Oven Controls 

section.

Strong odor from 

range or smells hot.

Self-clean was started for 

the first times or from a new 

range.

It is normal for odors to occur during self-clean, especially 

during the first self-clean cycle. It is recommend to ventilate 

the kitchen area. Open any windows and if available turn on 

an exhaust fan or overhead range hood during the self-clean 

cycle.

Unable to remove 

items from oven after 

starting self-clean.

Oven door locks immediately 

after setting self-clean.

Press cancel to stop self-clean. Wait for the oven door to 

unlock. Once unlocked, remove any items left in the oven, 

close the oven door and set for self-clean again.

Oven door did not 

unlock after the self-

clean cycle.

Oven is too hot.

Allow about 1 hour after the self-clean cycle for the oven to 

cool enough before the oven door will unlock.

Self-clean feature will 

not start.

Incorrect control setting.

Carefully follow the preparation and programming instructions 

under Self-cleaning.

Oven door open.

The oven door must lock before the self-clean cycle will start. 

Be sure the oven door is closed before starting self-clean.

Self-clean will not 

restart.

The control has determined 

oven is still too hot to restart 

self-clean (some models).

In some cases after cancelling self-clean, you may be required 

to wait up to 4 hours before the self-clean feature may be used 

again. Watch display for any messages.

Soil not completely 

removed after self-

cleaning cycle.

Heavy soils. Clean time too 

short or spillovers were left 

inside oven.

Set self-clean feature for maximum cleaning time. Remove any 

excessive spillovers from oven before starting self-clean. 

Carefully follow preparation instructions under “Self-cleaning”.

Failure to clean soil from the 

oven frame, the door liner 

outside the oven door gasket 

and the small area at the front 

center of the oven bottom.

These areas are not within the self-cleaning area, but get hot 

enough to burn on residue. Clean these areas before starting a 

self-clean cycle. Burned-on residue may be cleaned with a stiff 

nylon brush and water or a nylon scrubber. Be careful not to 

damage the oven gasket.

Interrupted by power outage.

Once power is restored restart self-clean.

Powdered ash inside 

the oven cavity after 

self-clean cycle.

This is normal. The 

temperature of the self-clean 

feature turned dirt to ash.

Wait for the oven to completely cool. Wipe away any residue 

or powdered ash from the oven interior using a clean damp 

cloth or paper towel.

Oven rack finish is 

dull or discoloring.

Oven racks left inside oven 

during self-clean.

Remove all racks from oven before starting self-clean.  Clean 

after removing from the oven using a mild, abrasive cleaner 

following manufacturer’s instructions. Thoroughly rinse and dry.

Oven rack no longer 

slides in or out of 

oven easily.

Oven racks left inside oven 

during self-clean.

Remove all racks from oven before starting self-clean. To ease 

rack movement, remove from oven and clean if needed. Then 

apply a small amount of vegetable oil to a paper towel and 

wipe oil on edges of oven racks. Do not use lubricant sprays.