BlueStar RNB606GHCV1NG Istruzione Sull'Installazione
P/N 750301 Page 6
•
This appliance has been designed to be
installed directly against rear walls and
side base cabinets. It cannot be installed
directly against tall side cabinets, side
walls, tall appliances or base cabinets ex-
tending beyond 24 inches [610 mm].
installed directly against rear walls and
side base cabinets. It cannot be installed
directly against tall side cabinets, side
walls, tall appliances or base cabinets ex-
tending beyond 24 inches [610 mm].
•
Side trims must be at least 11/16 inch
[17.5 mm] above the adjoining counter
top surfaces.
[17.5 mm] above the adjoining counter
top surfaces.
•
Any openings in the back wall or the floor
of the installation site must be sealed.
of the installation site must be sealed.
•
Each gas appliance shall be located with
respect to building construction and other
equipment to permit access to the appli-
ance. Such access and clearance is neces-
sary for cleaning and servicing.
respect to building construction and other
equipment to permit access to the appli-
ance. Such access and clearance is neces-
sary for cleaning and servicing.
•
Due to its size and weight, a rolling lift
jack, air sled or pallet jack should be used
to move the appliance into position.
jack, air sled or pallet jack should be used
to move the appliance into position.
•
Do not push against the edges or sides of
any appliance in an attempt to slide it into
position. Although all metal parts are de-
any appliance in an attempt to slide it into
position. Although all metal parts are de-
burred during the manufacturing process,
serious injury could occur if the appliance
were to move suddenly while being posi-
tioned. We recommend you use gloves
during the installation process.
serious injury could occur if the appliance
were to move suddenly while being posi-
tioned. We recommend you use gloves
during the installation process.
•
Do not use the louvered kick panel or
oven door handle to push or pull the appli-
ance into position.
oven door handle to push or pull the appli-
ance into position.
•
For optimum performance the appliance
should be leveled during installation. A
carpenter type level should be placed on
the unit three ways: side to side; front to
back; diagonally.
should be leveled during installation. A
carpenter type level should be placed on
the unit three ways: side to side; front to
back; diagonally.
•
Appliances on bullet legs may be leveled
by screwing the various leg assemblies in
or out. If the appliance is installed in an
island or cabinet cut-out the edges should
be shimmed with small metal coupons.
by screwing the various leg assemblies in
or out. If the appliance is installed in an
island or cabinet cut-out the edges should
be shimmed with small metal coupons.
SITE PREPARATION