Summit CLIM15 Manuale Proprietario

Button Press  To 

turn 

the Ice Maker on/off, 

press and hold this button 
for approximately 3 seconds. 

1. Turn off water supply. 
2. Disconnect line from the ice 

maker. 

3. Position water supply line in 

a bucket. 

4. Turn on water and make 

sure water falls into bucket. 

5. Before reconnecting the 

water supply line to the ice 
maker, make sure the 
water is turned off, then 
reconnect the water supply 
line to the ice maker. 

 

① 

a. Unscrew the drain cap (12) 

located on the back of the 
unit and let out the water. 
(Refer to Page 5, Fig. B.) 

Button 

Press 

Small amount of ice 

Button 

Press 

Medium amount of ice 

Button 

Press 

Large amount of ice 

Indicator Light 

ON 

Small amount of ice is selected. 

FLASHING 

Water tank is full.    ① 

Indicator Light 

ON 

Medium amount of ice is selected. 

Indicator Light 

ON 

Large amount of ice is selected. 

FLASHING 

Ice bin is full of ice.  ④ 

Indicator Light 

ON 

Compressor is working. 

OFF 

Compressor stopped working. 

FLASHING 

Stand by condition. 

Indicator Light 

Flashing at the 
same time. 

Ice maker low on water.② 

Indicator Light 

Flashing at the 
same time. 

Sensor breakdown   ③ 

b. After draining out all the water from the outside water tank, reconnect unit to power and it will continue to run normally. 
c. If “Drain pump mode” is chosen, please confirm the “Pumped water outlet switch” is in the“ON” position. If it is in the 

correct position

 

but you still

 

get a WARNING ALARM after you power off the unit, please contact a service center

.

 

d. If “Manual drainage system mode” is chosen, the outside water tank will be full of water within one or two weeks 

depending on differences in ambient temperatures, please drain the water. 

②

a. Check if outside water supply is functioning normally. Please see “Checking the water supply” box above. 
b. The icemaker will remove faults automatically within 30 minutes and work normally when outside water pipe is functioning. 

c. Press “

” button and turn on the unit again if icemaker does not function normally after 30 minutes; 

d. If the icemaker still shows a WARNING ALARM after the above process is repeated, contact the service center. 

③ 

“Sensor breakdown” Please contact our authorized service center. 

④

a. Check if the ice bucket is full. If so, remove the ice, and the alarm will stop. 
b. If the ice bucket is not full when the alarm sounds, check to see if the ice maker cover plate is stuck. Clear any obstruction and 

replace the cover. The alarm should stop. 

c. When there is an insufficient water supply, the ice maker cover plate may stick and the “bucket full” alarm will sound. Remove any 

ice from around the cover plate and check that the water supply is sufficient. The alarm should stop. 

9