Monogram ZCGP150RII Istruzione Sull'Installazione
Installation Preparation
6
UNPACKING THE COMPACTOR
1
• Move the compactor close to the installation
location.
• Use a section of the shipping carton to protect
the finished floor.
• Do not use the handle to lift the compactor.
• Remove all protective packaging materials such
as tape or shipping pads. Remove waxy residue
caused by shipping material with a mild solution
of liquid household cleaner and water.
caused by shipping material with a mild solution
of liquid household cleaner and water.
• Check that the power supply cord is attached to
the cord clip on the rear of the compactor.
IMPORTANT: Use the shipping carton as a pad.
Do not slide the compactor across a finished floor.
Damage will occur.
Do not slide the compactor across a finished floor.
Damage will occur.
Cord clip
REPLACING THE DOOR TOEKICK
(Optional for ZCGS150SS and
ZCGP150II Models Only)
(Optional for ZCGS150SS and
ZCGP150II Models Only)
2
• Open the compactor drawer and remove any
shipping materials or other items shipped in the
drawer.
drawer.
• Do not remove the compactor bag (if installed).
• Grasp the sides of the drawer and lift it out of the
compactor. Place the drawer on a protected
surface. The drawer can scratch a finished floor.
surface. The drawer can scratch a finished floor.
ZCGS150SS and ZCGP150II Models are supplied
with extra toekicks that can replace the toekicks
assembled on the compactor.
with extra toekicks that can replace the toekicks
assembled on the compactor.
• Lay the drawer on its side.
• Remove 2 foot pedal screws on the side of
the drawer. Lift off the foot pedal.
• Remove 2 door toekick screws. Remove door
toekick.
• Install the new door toekick using the original
screws.
• Reinstall the foot pedal using the original screws.
See Step 5 for instructions on replacing the top
toekick and base toekick.
toekick and base toekick.
Door
Toekick
screw
Toekick
screw
Door
Toekick
screw
Toekick
screw
Door
Toekick
Toekick
Foot pedal