Marvel 8SWCEBSGLL Istruzione Sull'Installazione

Do NOT under any circumstance use a light tube that exceeds 10 

watts!

To replace a light tube, use a 1/4” hex-head driver, remove the 

two hex-head screws that hold a cover plate over the back sec-

tion of the light tube.  Set the screws and cover plate aside for 

reassembly later.

Using a small flat-blade screwdriver, gently lever the front sec-

tion of the light tube down to allow it to be pulled clear of the 

light housing.

Disconnect the two insulated electrical connectors from the cabi-

net’s electrical cable and discard the old light tube.  Reconnect 

the electrical connector of the new light tube to the cabinet’s 

electrical cable connectors.  Make sure it is secure and fully 

installed.

Carefully realign the light tube’s electrical terminal back into 

the rear of the light enclosure channel making sure not to crimp 

them.  Gently insert the light tube along the length of the light 

enclosure channel.  Press the light tube gently into the light 

enclosure channel.  Only a small part of the light tube should 

project below the ceiling of the wine cellar.  DO NOT USE A HAM-

MER TO FIT THE LIGHT TUBE.

Place the light tube terminal cover plate back in the original 

position on the light enclosure’s flange.  Reuse the original two 

screws to secure it in place.  Plug the wine cellar into the electri-

cal socket.  Check to see if the light tube operates properly.  Your 

light tube’s replacement is complete.

The 3SWCE and 3SWCCE use one 6 watt light tube in the top of 

the cabinet while the 6SDZE uses two, 6 watt light tubes to illu-

minate the interior of the dual zone wine cellar: one in the upper 

compartment and one in the lower compartment.  The upper 

compartment light tube is located behind the display housing.  

The lower compartment light tube is located on the underside of 

the divider that separates the compartments. 

To replace the light tube, disconnect power to the unit.  Use a 

hex-head driver to remove the two hex-head screws holding the 

old light tube in place.  Disconnect the electrical plug from the 

cabinet’s electrical receptacle and discard the old light tube.  Re-

connect the electrical plug of the new light tube to the cabinet’s 

electrical receptacle.  Make sure it is secure and fully installed.

Using the hex-head driver, re secure the two hex-head screws to 

secure the light tube in place.  Plug the unit into the electrical 

socket.  Check to see if the light tube operates properly.  Your 

light tube’s replacement is complete.

The light tubes are not covered by your warranty.  Replacement 

tubes can be obtained from your dealer or from AGA MARVEL.

If a power failure occurs, try to correct it as soon as possible.  

Minimize the number of door openings while the power is off so 

as not to adversely affect the unit’s temperature.  

25

Hex head

screw

Light 

assembly

Ground 

wire

Plug

Figure 23

Figure 22

Channel in

liner

Light tube

Cover plate

Connector