Dacor RDW24I Guida All'Installazione

Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com

Handle mounting 

studs 

Handle mounting 

studs 

Set screw 

holes

Set screw 

holes

STEP 1   Place the handle on the front of the dishwasher. Slide 

the holes on the back over the handle mounting studs. 

Make sure the set screw holes on the handle are fac-

ing toward the bottom. You may need to loosen the set 

screws using a 3/32” Allen wrench to allow the handle 

to slide into place.

STEP 2   Carefully tighten the set screws into place using the

3/32” Allen wrench. Be careful not to scratch the finish.

STEP 3   Check to make sure the handle is firmly attached.
STEP 4   Open the door to make sure it stays open at any angle. 

If it tends to fall open or pull shut on its own, adjust the 

springs according to the dishwasher installation instruc-

tions.