Vinotemp VTICEMAKER15 Manuale Proprietario

14 

 

 

 

Most common problems can be solved easily, saving you the cost of a possible service call. Try the 
following suggestions to see if you can solve the problem before contacting Vinotemp at 
info@vinotemp.com.  

 

 
Ice Maker does not operate 

•  Ensure ice maker is plugged in to electrical outlet. 
•  Check for a blown fuse and replace if necessary. 
•  Check if the power button is on. 
•  Remove any ice cubes and ensure ice-full probe is free of ice. 

Water does not feed in after 
Ice Maker starts 

•  Turn on the water supply tap. 
•  Reconnect the water supply line.   

 
Ice Maker makes ice but bin 
does not fill completely 

•  Clean the condenser if dirty. 
•  Check for proper air flow and ventilation. 
•  Ensure that the ice maker is not near any heat source. 
•  Ensure that the ambient temperature and water temperature is 

within the acceptable range.  

Water is leaking from the Ice 
Maker 

•  Normal condensation or water may fall during ice removal.  
•  Tighten the water supply connection to ensure no leakage. 
•  Ensure drain pipe is not higher than drain outlet. 

Ice cubes are partially formed 
or white at the bottom 

•  Check for proper water supply pressure. 
•  Check if water supply or filter is restricted. 
•  Check for a water leak at the water trough.  

Ice Maker makes noise during 
operation 

•  Sounds may be normal, refer to “Sounds” (pg. 12). 
•  Level and lock the feet to ensure level standing. 

Ice Maker stops suddenly 
while making ice 

•  Check the power supply line. 
•  Ambient temperature may be high. Disconnect the ice maker 

until the ambient temperature is within allowed range. 

•  The ice storage bin may be full. Remove some ice cubes and 

ensure the ice-full probe is free of ice.  

Scaling occurs frequently 

•  The hardness level of the water may be too high. Install a 

water-softening device in front of the water inlet.   

Water leaks from the ice 
storage bin 

•  The drain hole below the ice storage bin may be blocked. 

Remove the ice storage bin and clean the drain hole.  

•  The drain hose may be improperly placed higher than the floor 

of the ice storage bin. Check the hose to make sure water can 
drain without hindrance.