Maytag MBF2258DEH Illustrazioni Dimensionali
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
Bottom Mount Refrigerator
MBF1958DE MBF2258DE
Electrical: A 115-volt, 60-Hz, AC-only,
15- or 20-amp fused, grounded electrical
supply is required. It is recommended
that a separate circuit serving only your
refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of
installation, cleaning, or removing a
light bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending
on the model) to OFF and then disconnect
the refrigerator from the electrical source.
When you are finished, reconnect the
refrigerator to the electrical source and
reset the control (Thermostat,
Refrigerator or Freezer Control depending
on the model) to the desired setting. See
“Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207
and 827 kPa) is required to operate ice
maker and water dispenser. If you have
questions about your water pressure, call
a licensed, qualified plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis Water Supply:
If a reverse osmosis water filtration
system is connected to your cold water
supply, the water pressure to the reverse
osmosis system needs to be a minimum
of 40 to 60 psi (276 to 414 kPa).
15- or 20-amp fused, grounded electrical
supply is required. It is recommended
that a separate circuit serving only your
refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of
installation, cleaning, or removing a
light bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending
on the model) to OFF and then disconnect
the refrigerator from the electrical source.
When you are finished, reconnect the
refrigerator to the electrical source and
reset the control (Thermostat,
Refrigerator or Freezer Control depending
on the model) to the desired setting. See
“Using the Controls.”
Water: A cold water supply with water
pressure between 30 and 120 psi (207
and 827 kPa) is required to operate ice
maker and water dispenser. If you have
questions about your water pressure, call
a licensed, qualified plumber.
IMPORTANT: The pressure of the water
coming out of a reverse osmosis system
going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
Reverse Osmosis Water Supply:
If a reverse osmosis water filtration
system is connected to your cold water
supply, the water pressure to the reverse
osmosis system needs to be a minimum
of 40 to 60 psi (276 to 414 kPa).
To ensure proper ventilation for your refrigerator, allow for a Z⁄x" (1.25 cm) space on each side and
at the top. Allow at least 1" (2.54 cm) between back of cabinet and the wall. If your refrigerator has
an ice maker, make sure you leave some extra space at the back for the water line connections.
If you are installing your refrigerator next to a fixed wall, leave 2Z⁄x" (6.3 cm) minimum on the hinge
If you are installing your refrigerator next to a fixed wall, leave 2Z⁄x" (6.3 cm) minimum on the hinge
side (depending on your model) to allow for the door to swing open.
NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other
NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other
heat source, nor in a location where the temperature will fall below 55°F (13°C).
LOCATION REQUIREMENTS
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Instructions packed with product. Specifications subject to change without notice.
Ref. W10621529A
3/15
4
1
A
overall
B
top of
cabinet
H
not incl.
handle
F
incl.
handle
E
D
cabinet
G
90˚
C
Model
Number
Model Size
Height -
Overall
“A”
Height -
Top of
Cabinet
“B”
Depth -
Doors Open
90°
“C”
Depth -
Drawer
Open
“D”
Depth -
With
Handles
“E”
Depth -
Without
Handles
“F”
Depth -
Cabinet
Only
“G”
Width -
Cabinet
“H”
MBF1958DE
18.7 cu. ft.
67"
(170.2 cm)
65Z⁄x"
(166.4 cm)
59"
(149.9 cm)
50C⁄v"
(128.9 cm)
33C⁄,"
(84.8 cm)
30M⁄,"
(78.4 cm)
28Z⁄,"
(71.4 cm)
29C⁄v"
(75.6 cm)
MBF2258DE
22.1 cu. ft
70"
(177.8 cm)
68Z⁄x"
(174.0 cm)
62"
(157.5 cm)
50C⁄v"
(128.9 cm)
33C⁄,"
(84.8 cm)
30M⁄,"
(78.4 cm)
28Z⁄,"
(71.4 cm)
32B⁄,"
(82.9 cm)
2
¹⁄₂
" (6.3 cm)
¹⁄₂
" (1.25 cm)