Danby DFF100C1BSLDB Manuale Proprietario
Troubleshooting
Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free
Number for assistance.
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s Toll Free
Number for assistance.
Tel: 1-800-26-
(1-800-263-2629)
1) Unit does not work.
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being used.
• Check connection of power cord
at power source.
• Plug in unit.
• Use proper voltage.
2) Refrigerator running too
frequently.
• Temperature control too cold.
• Door not closed.
• Hot food inserted.
• Doors open too long/often.
• Close proximity to heat source or direct
sunlight.
• Check/adjust settings as needed.
• Close the door securely.
• Cool food before inserting.
• Minimize door openings/duration.
• DO NOT place unit close to heat sources
or in direct sunlight.
3) Internal temperature too
cold.
• Temperature set too cold.
• Check/adjust settings as needed.
4) Internal temperature
not cold enough.
• No power to unit.
• Power cord is unplugged.
• Wrong voltage is being used.
• Temperature control too warm.
• Hot food inserted.
• Doors open too long/often.
• Air flow obstruction.
• Close proximity to heat source or direct
sunlight.
• Check connection of power cord at
power source.
• Plug in unit.
• Use proper voltage.
• Check/adjust settings as needed.
• Cool food before inserting.
• Minimize door openings/duration.
• Allow room for air to circulate around the
unit.
• DO NOT place unit close to heat sources
or in direct sunlight.
5) Freezer not cold enough.
• Temperature control too warm.
• Door not closed.
• Hot food inserted.
• Doors open too long/often.
• Wrong voltage is being used.
• Check/adjust settings as needed.
• Close door securely.
• Cool food before insterting.
• Minimize door openings/ duration.
• Use proper voltage.
6) Light will not work.
• No power to unit.
• Power cord is unplugged.
• Bulb is loose/needs replacing.
• Door switch is stuck.
• Check connection of power cord to
power source.
• Plug in unit.
• Tighten or replace bulb.
• Check the switch for obstructions, clean
if necessary.
PROBLEM
POSSIBLE CAUSE
SOLUTION
8