Monogram ZIC30GNHII Guida Alla Progettazione

1. Remove all door and drawer hooks from the unit and

screw them to the custom panels, aligning them with the
lowest set of predrilled holes for Monogram Panel Kits on
the FF door panel.

2. Attach top L-Bracket to FF panel.
3. If you had custom handles made and they are not

currently attached to your panels, do so now.

4. Open the fresh food door to attach the fresh food panel.  
5. Slide the hooks on the fresh food panel into the slots of the

door, and lower the hooks into place. Make sure the
bracket on the top of the panel slides over the screw posts
on top of the door. The brackets will rest on top of the nuts.

6. Adjust the screw posts up or down under the bracket

on top of the door to level the panel.  

7. Lock the panel to the door by installing the nuts

provided onto the screw posts on top of the door.
Next, screw the L-bracket provided into the bottom of
the door and the panel.

Hooks

Top of

Fresh Food

Panel Door

Nut

Nut

Slots

Bracket

Screw Post

7. Install the Freezer drawer panel by sliding the brackets

up into place (the opposite direction of the hooks on the
fresh food panel and Convertible drawer). .

8. Once the drawer panel is placed fasten the panel to the

drawer by screwing the bottom bracket into the panel
with the screws provided. 

9. Repeat for the second drawer by sliding the hooks down

instead of up.

10. If using custom toekick attach the toekick panel by

placing Velcro on the back of the panel, and on the front
of the toekick. If using SS toekick it is magnetic.

11. Adjust drawer alignment using lower brackets as

needed to create uniform gaps.

Slots

Hooks

Screw Post

Bracket

Bracket

Fresh

Food
Door

Convertible

drawer

Freezer
Drawer

Freezer

Drawer

The lower brackets on the Fresh Food & Convertible Drawer

should not be installed until after the panel is in place.

Hooks on the Freezer
drawer panel face up.