Maytag MFF2558DE Utilizzo E Cura

1. Press and hold the Door Alarm touch pad for 3 seconds. The 

preference name will appear in the Freezer display and the 
preference status (F or C) or (ON or OFF) will appear in the 
Refrigerator display.

2. Use the Freezer (+) or (-) touch pads to scroll through the 

preference names. When the desired preference name is 
displayed, press the Refrigerator (+) or (-) touch pads to 
change the preference status.

3. Set your preferences by pressing and holding the Door Alarm 

touch pad for 3 seconds, or by shutting the refrigerator 
compartment door. 

You can control the amount of humidity in the moisture-sealed 
crisper. Depending on your model, adjust the control to any 
setting between FRUIT and VEGETABLES or LOW and HIGH.
FRUIT/LOW (open) for best storage of fruits and vegetables with 
skins. 
VEGETABLES/HIGH (closed) for best storage of fresh, leafy 
vegetables. 

IMPORTANT: Flush the water system before turning on the ice 
maker. See “Water Dispenser.” 

To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to the 
OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made, 
the ice cubes will fill the ice storage bin and the ice cubes will 
raise the wire shutoff arm to the OFF (arm up) position. Do not 
force the wire shutoff arm up or down.

NOTE: Turn off the ice maker before removing the ice storage bin 
to serve ice or to clean the bin. This will keep the ice cubes from 
dropping out of the ice maker and into the freezer compartment. 
After replacing the ice storage bin, turn on the ice maker. 

■

The ice maker should produce a complete batch of ice 
approximately every 3 hours. 

■

To increase ice production, lower the freezer and refrigerator 
temperature. See “Using the Controls.” Wait 24 hours 
between adjustments. 

■

Allow 24 hours to produce the first batch of ice. Allow 3 days 
to completely fill the ice storage bin. Discard the first three 
batches of ice produced.

■

The quality of your ice will be only as good as the quality of the 
water supplied to your ice maker. Avoid connecting the ice 
maker to a softened water supply. Water softener chemicals 
(such as salt) can damage parts of the ice maker and lead to 
poor quality ice. If a softened water supply cannot be avoided, 
make sure the water softener is operating properly and is well 
maintained.

■

Do not store anything on top of the ice maker or in the ice 
storage bin.

IMPORTANT: 

■

After connecting the refrigerator to a water source or replacing 
the water filter, flush the water system. Use a sturdy container 
to depress and hold the water dispenser lever for 5 seconds, 
then release it for 5 seconds. Repeat until water begins to 
flow. Once water begins to flow, continue depressing and 
releasing the dispenser lever (5 seconds on, 5 seconds off) 
until a total of 4 gal. (15 L) has been dispensed. This will flush 
air from the filter and water dispensing system, and prepare 
the water filter for use. Additional flushing may be required in 
some households. As air is cleared from the system, water 
may spurt out of the dispenser.  

NOTE: After 5 minutes of continuous dispensing, the 
dispenser will stop dispensing water to avoid flooding. To 
continue dispensing, press the dispenser button again. 

■

Allow 24 hours for the refrigerator to cool down and chill 
water. Dispense enough water every week to maintain a fresh 
supply.

1. Hold a container under the dispenser while pressing the 

button.

2. Release the button to stop dispensing.