Maytag MSB26C6MD Manuale Proprietario

Pagina di 86
18
4. There is no need for routine condenser cleaning in normal 
home operating environments. If the environment is 
particularly greasy or dusty, or there is significant pet traffic in 
the home, the condenser should be cleaned every 2 to 
3 months to ensure maximum efficiency.
If you need to clean the condenser:
Remove the base grille. See the “Door Removal” 
instructions, either in the User Instructions or the 
Installation Instructions and Owner’s Manual, or in the 
separate instruction sheet provided with your refrigerator.
Use a vacuum cleaner with a soft brush to clean the grille, 
the open areas behind the grille and the front surface area 
of the condenser.
Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
Lights
IMPORTANT: The light bulbs in both the refrigerator and freezer 
compartments of your new refrigerator may use LED technology. 
If the lights do not illuminate when the refrigerator and/or freezer 
door is opened, call for assistance or service. In the U.S.A., call 
1-800-253-1301. In Canada, call 1-800-807-6777.
Light Styles: 
The dispenser lights are mini LEDs that cannot be changed.
The interior lights vary by model. 
Some models have mini LEDs that cannot be changed.
Some models have full-size LED bulbs that can be 
changed. To order replacement LED bulbs, call 
1-800-253-1301 (U.S.A.) or 1-800-807-6777 (Canada). 
NOTE: Some LED replacement bulbs are not 
recommended for wet/damp environments. The 
refrigerator and freezer compartments are considered to 
be wet/damp environments. If using a brand of LED bulb 
other than the recommended Whirlpool LED bulb, read 
and follow all instructions on the replacement bulb’s 
packaging before installing it.
Some models have incandescent 40-watt bulbs that can 
be changed.
NOTE: Not all replacement bulbs will fit your refrigerator. 
Do not use an incandescent bulb in excess of 40 watts.
To Change a Light Bulb:
1. Unplug refrigerator or disconnect power.
2. Remove the light shield, as explained in the following 
sections. 
NOTE: To clean the light shield, wash it with warm water and 
liquid detergent. Before reinstalling, thoroughly rinse and dry 
the shield.
3. Replace the burned-out light bulb, as explained in the 
following sections.
4. Reinstall the light shield, as explained in the following 
sections.
5. Plug in refrigerator or reconnect power.
Refrigerator Compartment - Upper Lights
Light Shield Removal:
Slide the light shield toward the rear of the refrigerator and 
remove it from the light housing.
Replacement Bulb:
If the burned-out light is a full-size LED bulb, replace it with 
Whirlpool part number W10574850A (a 2.0 watt LED bulb).
If the burned-out light is an incandescent bulb, replace it with 
an incandescent appliance bulb of the same size, shape and 
wattage (40-watt maximum). 
Light Shield Reinstallation:
Align the light shield in the grooves at the bottom edge of the 
light housing, then slide it forward until it snaps into place.
Whirlpool
Part Number
W10574850A
(2.0 watts)
Whirlpool
Part Number
W10565137A
(3.6 watts)