InSinkErator F201R Guida Specifiche
Model
F-201R Replacement Filter
For cleaner, fresher-tasting water
Submittal Sheet
Job Specifications
Specifications
Instant Hot Water Dispensers
HWD307-07D-45-02
Printed in USA
1-800-558-5700
www.insinkerator.com
Dimensions
• Includes 2 replacement filters for use
with InSinkErator water filtration system
• Reduces Chlorine, taste and odor for
clean, refreshing taste
• Sanitary, quick-change filter cartridge
makes replacement easy. A simple twist
is all it takes!
is all it takes!
• 6-12 month recommended filter
cartridge replacement
F-201R Chemical & Mechanical Reduction Filter Specifications: This cartridge provides mechanical and chemical
reduction of dirt/rust, chlorine taste and odor, and particulates.
reduction of dirt/rust, chlorine taste and odor, and particulates.
Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator
®
directly at 1-800-558-5700.
Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private
well water supply, water pressure of 20-120 psi, water temperature of 33˚F–100˚F. Except as noted, all testing
performed at pH = 7.5±0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.
well water supply, water pressure of 20-120 psi, water temperature of 33˚F–100˚F. Except as noted, all testing
performed at pH = 7.5±0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.
Contact an authorized InSinkErator service agent for repairs or replacement components.
Pressure: 20-120 psi
Temperature: 33
º
F - 100
º
F
Flow Rate: 0.75 gpm
Capacity: 500 gallons
REPLACEMENT ELEMENT
The Emerson logo is a trademark and
service mark of Emerson Electric Co.
InSinkErator may make improvements and/or
changes in the specifications at any time, in its sole
discretion, without notice or obligation and further
reserves the right ot change or discontinue models.
© 2009 InSinkErator, a division of
Emerson Electric Co. All Rights Reserved.
Filter Capacity
Temperature
Range
Range
Pressure
Flow Rate
Shipping Weight
500 gallons
20-120 psi
0.75 gpm
Approximately 2.0 lbs.
Incoming cold water
can be from 33˚F to
100˚F (1˚C to 38˚C).
For cold water
use only.
can be from 33˚F to
100˚F (1˚C to 38˚C).
For cold water
use only.
3-1/4"
8-3/4"
,
The Next
Necessity
™
System Tested and Certified by NSF International
against NSF/ANSI Standard 42 for the reduction of
Chlorine taste and odor.
against NSF/ANSI Standard 42 for the reduction of
Chlorine taste and odor.