Summit FF7x Utilizzo E Cura
Ice Formation on the Inner Rear Wall
Possible Causes
*The door does not seal well (clean the gasket if it is contaminated, or
replace it if it is damaged).
*The door was frequently opened or it was left opened for too long.
*The food stored in the refrigerator was warm.
replace it if it is damaged).
*The door was frequently opened or it was left opened for too long.
*The food stored in the refrigerator was warm.
Solution
-
As long as the defrost water runs through the channel, out of the
opening and into the drain pan on the compressor, automatic
defrosting of the appliance is assured. In case the ice formation on
the inner back wall is increased (1/8”), ice should be manually
defrosted.
Set the thermostat knob to STOP (0) position and leave the door
open. Never use electric devices for defrosting and do not scrape
the ice or frost layer with sharp objects. After defrosting is
complete, turn the knob to desired position and close the refrigerator
door.
defrosting of the appliance is assured. In case the ice formation on
the inner back wall is increased (1/8”), ice should be manually
defrosted.
Set the thermostat knob to STOP (0) position and leave the door
open. Never use electric devices for defrosting and do not scrape
the ice or frost layer with sharp objects. After defrosting is
complete, turn the knob to desired position and close the refrigerator
door.
.
Problem #3
Water is Leaking from the Refrigerator
Possible Cause/Solution
In case the water discharge outlet is clogged, or the defrost water drips
over the channel causing water to leak from the refrigerator, try the
following suggestion:
*Clean the clogged opening with a plastic straw
*Manually defrost the increased ice layer according to instructions
listed above.
Instructions for Use
Noise
11