Sharp R1880LSRT Manuale Utente

Pagina di 32
8
ExTERIOR
The  outside  surface  is  precoated  metal  and  plastic. 
Clean the outside with mild soap and water; rinse and 
dry with a soft cloth. Do not use any type of household 
or abrasive cleaner.
dOOR
Wipe the window on both sides with a damp cloth to 
remove any spills or spatters. Metal parts will be easier 
to maintain if wiped frequently with a damp cloth. Avoid 
the use of harsh abrasives.
TOuCH CONTROl PANEl
Care  should  be  taken  in  cleaning  the  touch  control 
panel.  If  the  control  panel  becomes  soiled,  open  the 
oven door to inactivate the control panel before clean-
ing. Wipe the panel with a cloth dampened slightly with 
water only. Dry with a soft cloth. Do not scrub or use 
any sort of chemical cleaners. Avoid the use of excess 
water. Close door and touch 
Stop/Clear.
INTERIOR - AFTER MICROWAvE 
COOKING
The  oven  walls,  ceiling  and  floor  are  stainless  steel. 
Cleaning after microwave cooking is easy because no 
heat  is  generated  to  the  interior  surfaces;  therefore, 
there is no baking and setting of spills or spattering. To 
clean the interior surfaces, wipe with a soft cloth and 
warm  water.  DO  NOT  USE ABRASIVE  OR  HARSH 
CLEANERS OR SCOURING PADS. For heavier soil, 
use mild soap; rinse thoroughly with hot water.
INTERIOR- AFTER CONvECTION,                            
MIx OR bROIl COOKING
Spatters may occur because of moisture and grease. 
Wash  immediately  after  use  with  hot,  soapy  water. 
Rinse and polish dry. Harder to remove spatters may 
occur  if  oven  is  not  thoroughly  cleaned  or  if  there  is 
long time/high temperature cooking. If so, you may wish 
to  purchase  an  oven  cleaner  pad  with  liquid  cleaner 
within it-not a soap filled steel pad-for use on stainless 
or porcelain surfaces. Follow manufacturer’s directions 
carefully and be especially cautious not to get any of the 
liquid cleaner in the perforations on the wall or ceiling or 
any door surfaces. Rinse thoroughly and polish dry.
WAvEGuIdE COvER
The waveguide cover is located on the ceiling in the 
oven cavity. It is made from mica so requires special 
care. Keep the waveguide cover clean to assure good 
oven performance. Carefully wipe with a damp cloth any 
food spatters from the surface of the cover immediately 
after they occur. Built-up splashes may overheat and 
cause smoke or possibly catch fire. DO NOT REMOVE 
THE WAVEGUIDE COVER. 
OdOR REMOvAl
Occasionally, a cooking odor may remain in the oven. 
To remove, combine 1 cup water, grated peel and juice 
of 1 lemon and several whole cloves in a 2-cup glass 
measuring cup. Boil for several minutes using 100% 
power. Allow  to  set  in  oven  until  cool.  Wipe  interior 
with a soft cloth.
TuRNTAblE/TuRNTAblE        
SuPPORT
The  ceramic  turntable  and  turntable  support  can  be 
removed for easy cleaning. Wash them in mild, sudsy 
water;  for  stubborn  stains  use  a  mild  cleanser  and 
scouring sponge as described above. They are also 
dishwasher-safe using top rack. 
OvEN RACKS
The high and low baking racks can be removed for easy 
cleaning  and  stored  away  from  the  microwave  oven 
when racks are not needed. After each use, wash them 
in mild, sudsy water. For any stubborn stains, use a mild 
kitchen  cleanser  and  scouring  sponge  as  described 
above. They are dishwasher-proof.
GREASE FIlTERS
Filters should be cleaned at least once a month. Never 
operate the fan or oven without the filters in place.
1.  Pull the tab toward the front of the oven, down slightly 
and remove the filter. Repeat for the other filter.
2.  Soak the filters in a sink or dish pan filled with hot 
water  and  detergent.  DO  NOT  use  ammonia  or       
other alkali; they will react with the filter material and 
darken it.
3.  Agitate and scrub with a brush to remove embedded 
dirt.
4.  Rinse thoroughly and shake dry.
5.  Replace by fitting the filter back into the opening.
Tab
Grease 
filter
C L E A N I N G   A N D   C A R E