Moen YB0892 Foglio Delle Specifiche
2 5 3 0 0 A L M O E N D R I V E
N O R T H O L M S T E D , O H 4 4 0 7 0
C O R P O R A T E H E A D Q U A R T E R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9
F A X : ( 8 0 0 ) 8 4 8 - 6 6 3 6
I N T E R N A T I O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0
F A X : ( 4 4 0 ) 9 6 2 - 2 7 2 6
C U S T O M E R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6
F A X : ( 8 8 8 ) 3 7 9 - 2 7 2 0
W W W . M O E N . C O M
Copyright Creative Specialties International
Literature #BA1721
Prime1
Mirror base, arms and ring are
constructed of zinc.
constructed of zinc.
YB0892BN
– Magnifying Mirror
Brushed Nickel Finish
YB0892CH
– Magnifying Mirror
Chrome Finish
Cleaning Instructions:
Stock Number:___________________Magnifying Mirror
By Creative Specialties
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Magnifying Mirror
YB0892
Arris
TM
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1. Remove the mounting plate from the body by loosening the setscrew.
2. Position the mounting plate on the wall in the desired location and
2. Position the mounting plate on the wall in the desired location and
mark holes.
3.
Drill ½” pilot holes in marked locations.
4. Unthread mounting screws from two toggle anchors and thread
through mounting plate holes. CAUTION: Be sure the toggle anchors
are partially threaded onto the screws and positioned so the toggle
collapses when pushed through the predrilled pilot holes. While
holding mounting plate (with screws and toggles installed), push both
toggle anchors through predrilled pilot holes.
are partially threaded onto the screws and positioned so the toggle
collapses when pushed through the predrilled pilot holes. While
holding mounting plate (with screws and toggles installed), push both
toggle anchors through predrilled pilot holes.
5. Tighten both screws until tight.
6. Place mirror assembly over the mounting plate with setscrew down.
6. Place mirror assembly over the mounting plate with setscrew down.
Tighten setscrew.