Capital COB484G2SSN Utilizzo E Cura

Pagina di 57
 
 
21  
 
 
MOIST (
30” or 36” Oven or PRIMARY Oven only on 48” or 60”) 
The MOIST feature adds a small amount of water to the oven every minute when cooking, resulting in moister cooked foods. Water 
is stored in a Water Reservoir behind the door and flows into an Evaporation Tray below the convection baffle inside the oven. 
 
IMPORTANT: 
ONLY  USE  DISTILLED  WATER  TO  FILL  THE  RESERVOIR.  Regular  tap  water  will  cause  a 
buildup of minerals in the orifice of the moist system and may cause clogging. 
 
NOTE: 
The Moist feature will not function unless a cooking mode is active and Pre-Heat is complete. 
 
WARNING: 
Moist mode should only be used with temperature settings over 250° F. Lower temperatures will 
not evaporate the water and water will accumulate in the evaporation tray. 
 
NOTE: 
The Moist feature will NOT function in SELF CLEAN or BROIL. 
 
IMPORTANT: 
Open the door as few times as possible during MOIST cooking. Frequent opening of the door will 
allow the moisture and heat to escape the oven and will prevent the mode from being effective. 
 
IMPORTANT: 
Prior to turning the oven on, make sure the Evaporation Tray is installed in the back of the oven. 
 
To use the MOIST feature, first add distilled water to the water reservoir. 
The  Moist  Water  Reservoir  is  located  at  the  right  rear  of  the  range  top.  The  cover  of  the  Moist  Reservoir  is 
attached to the reservoir by a stainless steel chain and can be removed by lifting by the chain or by lifting from 
the inner lip of the Reservoir tube. 
The Reservoir can be filled by removing the cover and pouring distilled water into the opening or it can be lifted 
and removed, filled, and replaced. The reservoir has a small white valve at the bottom which prevents spilling 
when the reservoir is not secured in its slot. 
After  filling,  replace  the  reservoir in  its  slot  and  make  sure  it  is  firmly  seated  by  pressing  down  slightly.  If  the 
reservoir is not properly seated it will not release water into the oven. 
 
Set the desired cooking mode and temperature and allow the oven to Pre Heat. If selected prior to completion of Preheat 
the MOIST feature will not begin to function until the PRE HEAT cycle is complete. 
 
Press  the  MOIST  button  to  start moist  cooking. When  activated, the  MOIST  button  will  be  illuminated  and  water  will  be 
added to the evaporation tray every minute after Pre-Heat 
Only use the MOIST feature with oven settings above 250° F. If the oven temperature is too low the water will 
not evaporate and may drip onto the oven bottom.  
 
The  MOIST mode  will  automatically  turn  Off  when  the  cooking mode  is cancelled  or  can  be manually  turned  Off  at  any 
time by pressing the MOIST button. When turned Off, the MOIST button light will turn Off. 
 
CLEANING THE EVAPORATION TRAY 
CAUTION! Only clean the Evaporation Tray when the oven is cool! 
The Evaporation Tray is inside the oven located directly below the convection baffle. Lift the Evaporation Tray 
up and remove from the oven. 
Use a damp cloth to and mild non-abrasive detergent to wipe out the interior of the container prior to use. Food 
particles and grease from cooking may fall into the container and get trapped. 
IMPORTANT! Always remove the evaporation tray from the oven prior to self cleaning. The tray is 
manufactured of high quality stainless steel and will discolor if left in the oven during self clean.