Maytag MFT2574DEM Manuale

Pagina di 116
Troubles
hooting
33
Doors
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search 
for “door closing and door alignment.” 
Water is leaking or dripping 
from the dispenser system
NOTE: A few drops of water 
after dispensing is normal.
The glass was not held under the 
dispenser long enough. 
Hold the glass under the dispenser 2 to 3 seconds after 
releasing the dispenser lever.
Water continues to drip 
from the dispenser beyond 
the first few drops.
The refrigerator has just been 
installed.
Flushing the water system removes the air from the lines 
which causes the water dispenser to drip. Flush the water 
system. See “Water and Ice Dispensers.”
The water filter was recently installed 
or replaced.
Flushing the water system removes the air from the lines 
which causes the water dispenser to drip. Flush the water 
system. See “Water and Ice Dispensers.”
Water is leaking from the 
back of the refrigerator
The water line connections were not 
fully tightened. 
See “Connecting the Water.”
Recently removed the doors and did 
not fully tighten water line connection
See “Refrigerator Doors and Drawer.”
Water from the dispenser is 
warm
Water from the dispenser is chilled to 
50°F (10°C).
This is normal.
The refrigerator has just been 
installed.
Allow 24 hours after installation for the water supply to cool 
completely.
A large amount of water was recently 
dispensed.
Allow 3 hours for the water supply to cool completely.
Water has not been recently 
dispensed.
The first glass of water may not be cool. Discard the first 
glass of water dispensed.
The refrigerator is not connected to a 
cold water pipe.
Make sure the refrigerator is connected to a cold water pipe. 
See “Water Supply Requirements.”
PROBLEM
POSSIBLE CAUSES 
SOLUTIONS
The doors will not close 
completely
The door is blocked open.
Move food packages away from door. 
A bin or shelf is in the way.
Push bin or shelf back into the correct position. 
Recently installed
Remove all packaging materials.
The doors are difficult to 
open
The door gaskets are dirty or sticky.
Clean gaskets and contact surfaces with mild soap and 
warm water. Rinse and dry with soft cloth.
The doors appear to be 
uneven
The doors need to be aligned, or the 
refrigerator needs to be leveled.
See “Refrigerator Leveling, Door Closing and Alignment.”
The refrigerator is unsteady 
or it rolls forward when 
opening and closing doors 
The refrigerator brake feet are not 
snug against the floor
Remove the base grille. Turn both brake feet (one on each 
side) clockwise, the same amount, until they are snug against 
the floor. See “Refrigerator Leveling, Door Closing and 
Alignment.”
PROBLEM
POSSIBLE CAUSES 
SOLUTIONS
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.