Maytag MFX2876DRM Scheda Tecnica

Pagina di 100
11
4. Install the water supply tube clamp around the water supply 
line to reduce strain on the coupling.
5. Turn shutoff valve ON.
6. Check for leaks. Tighten any connections (including 
connections at the valve) or nuts that leak.
7. On some models, the ice maker is equipped with a built-in 
water strainer. If your water conditions require a second water 
strainer, install it in the 
¹⁄₄" (6.35 mm) water line at either tube 
connection. Obtain a water strainer from your appliance 
dealer.
Complete the Installation
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See “Water and Ice Dispensers.”
NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to 
completely fill the ice storage bin. 
Handle Installation and Removal
Parts Included: Refrigerator door handles (2), Refrigerator 
drawer handle (1), Freezer drawer handle (1), 
¹⁄₈" hex key, spare 
setscrew(s) 
NOTE: Handle style may vary by model.
Install Handles
Refrigerator Doors
NOTE: Handle mounting setscrews are preinstalled inside the 
handle.
1. Remove the handles from the packaging inside the 
refrigerator, and place them on a soft surface.
2. Open a refrigerator compartment door. On the closed door, 
place a handle onto the shoulder screws so that the 
setscrews are facing the adjacent door.
3. Firmly push the handle toward the door until the handle base 
is flush against the door. 
4. While holding the handle, insert the short end of the hex key 
into the upper hole and slightly rotate the hex key until it is 
engaged in the setscrew. 
5. Using a clockwise motion tighten the setscrew just until it 
begins to contact the shoulder screw. Do not fully tighten. 
6. Repeat steps 4 and 5 to fasten the lower setscrew.
7. Once both setscrews have been partially tightened as 
instructed in the previous steps, fully tighten both setscrews.    
IMPORTANT: When the screws feel tight, tighten them an 
additional quarter-turn. The handle is not properly installed 
without this extra tightening.
8. Repeat steps 2 through 7 to install the other handle onto the 
adjacent refrigerator door. 
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, 
fire, or electrical shock.
WARNING
A. Shoulder screws
B. Setscrews inside the handle
A
B