Yamaha r-s201bl Manuale Proprietario

■ REC jacks

• The REC jacks output audio signals of the currently 

selected input (except when LINE 3 is selected).

• Volume level, tone control and balance settings do not 

affect the REC jacks.

■ Connecting speaker cables

When inserting speaker cables into the speaker terminals, insert 
only the bare speaker wire. If insulated cable is inserted, the 
connection may be poor and sound may not be heard.

Speaker impedance must be set as shown below.

■ Bi-wire connection

Bi-wire connection separates the woofer from the 
combined midrange and tweeter section.
A bi-wire compatible speaker has four binding post 
terminals. These two sets of terminals allow the speaker to 
be split into two independent sections. With these 
connections, the mid and high frequency drivers are 
connected to one set of terminals and the low frequency 
driver to another set of terminals.

Connect the other speaker to the other set of terminals in 
the same way.

When making bi-wire connections, remove the shorting bridges 
or cables on the speaker.

y

To use the bi-wire connections, press SPEAKERS A and 
SPEAKERS B so that both SP A and B light up on the front panel 
display.

8

Ω or higher

16

Ω or higher

(except for North 
America model)

8

Ω or higher

Remove approximately 
10 mm (3/8 in) of 
insulation from the end of 
each speaker cable.