Maytag MFX2876DRH Scheda Tecnica

3. Empty the ice bin.
4. Turn off the Temperature control(s). See “Using the 

Control(s).”

5. Unplug refrigerator.
6. Clean, wipe, and dry thoroughly.
7. Take out all removable parts, wrap them well, and tape them 

together so they don’t shift and rattle during the move.

8. Depending on the model, raise the front of the refrigerator so 

it rolls more easily OR raise the leveling screws so they don't 
scrape the floor. See “Adjust the Door(s)” or “Door Closing 
and Door Alignment.”

9. Tape the doors closed and tape the power cord to the back of 

the refrigerator.

When you get to your new home, put everything back and refer to 
the “Installation Instructions” section for preparation instructions. 
Also, if your refrigerator has an automatic ice maker, remember to 
reconnect the water supply to the refrigerator.

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, 
refer to the warranty page in this manual and scan the code with your mobile device, or visit www.maytag.com/product_help. 
In Canada, visit www.maytag.ca.
Contact us by mail with any questions or concerns at the address below:

In the U.S.A.:

Maytag Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692

In Canada:

Maytag Brand Home Appliances
Customer eXperience Centre
200 – 6750 Century Ave.
Mississauga, Ontario L5N 0B7

Please include a daytime phone number in your correspondence. 

 

Check electrical supply

Plug the power cord into a grounded 3 prong outlet.

Do not use an extension cord.

Make sure there is power to the outlet. Plug in a lamp to see if 
the outlet is working.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician. 

Check controls

Make sure the controls are turned on. See “Using the 
Control(s).”

New installation

Allow 24 hours following installation for the refrigerator to cool 
completely. 

NOTE: Adjusting the temperature controls to the coldest 
setting will not cool either compartment more quickly.

Refrigerator control is in Showroom mode 
(on some models).

If the refrigerator is in Showroom mode, cooling is turned off 
and “Showroom” will be illuminated on the control panel. See 
“Using the Control(s)” for more information.