Maytag MRT318FZDM Manuale Proprietario

If your model came with a Reversibility kit, please use the Brand 
Badge Placement template and the following instructions to 
install the Brand Badge on the opposite side of the freezer door. 

Brand badge removal tool

Brand badge template (on last page of User Instructions)

Door handle hole cap 

Scissors

Masking tape

1. Using the removal tool (provided), remove the brand badge 

from the freezer door by lifting up the right-hand side and 
peeling the badge away from the door from right to left.

NOTE: To avoid scratching the door, do not use a sharp or 
metallic object to pry the brand badge from the door. 

2. Rub a small amount of liquid dish soap over any adhesive 

residue with your fingers. Rinse the door with warm water and 
dry with a soft cloth.

3. Cut the template along the dotted lines that match the shape 

of the brand badge.

4. Align the edges of the template with the side and top of the 

freezer door, and then tape the template to the door. 

NOTE: When the template is correctly aligned, the hole in the 
door, where the handle was, will be within the cutout of the 
template, as shown.

5. Using the cutout as a guide, press the brand badge onto the 

freezer door making sure that the hole is completely covered. 

6. Slowly remove the template. 

IMPORTANT: Your refrigerator complies with American 
Disabilities Act (ADA) guidelines.

Your refrigerator has two front adjustable levelers - one on the 
right and one on the left. If your refrigerator seems unsteady or 
you want the doors to close easier, adjust the refrigerator's tilt 
using the following instructions:

1. Turn the leveler to lower or raise that side of the refrigerator. It 

may take several turns to adjust the tilt of the refrigerator.

■

To raise, turn the leveler to the right.

■

To lower, turn the leveler to the left.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the levelers and rollers 
which makes it easier to adjust.

2. Open both doors again to make sure they close as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling legs to the left; it may take several more 
turns.

NOTE: To keep the refrigerator level, you should turn both 
leveling legs the same amount.

3. Using a level, be sure that the refrigerator is still level side to 

side. Readjust if necessary.

If the space between your doors looks uneven, you can adjust it 
using the following instructions:

1. Depending on your model, remove the top hinge cover. 

2. Loosen the top hinge screws using a 

⁵⁄₁₆" socket or wrench.

3. Have someone hold the door in place or put a spacer 

between the doors while you tighten the top hinge screws.

4. Replace the top hinge cover, if removed in Step 1.