Frigidaire FGGF304DLF Guida All'Installazione

Pagina di 12
1
30" GAS RANGE INSTALLATION INSTRUCTIONS
Clearances and Dimensions
1. Location—Check location where the range will be 
installed. Check for proper electrical and gas supply, and 
the stability of floor.
30" minimum clearance between the top of the cooking 
surface and the bottom of an unprotected wood or metal 
cabinet; or 24" minimum when bottom of wood or metal 
cabinet is protected by not less than ¼" flame retardant 
millboard covered with not less than no. 28 MSG sheet 
steel, 0.015" stainless steel, 0.024" aluminum or  0.020" 
copper. The minimum clearance is 0" for the rear of the 
range. Follow all dimension requirements provided above 
to prevent property damage, potential fire hazard, and 
incorrect countertop and cabinet cuts.
Printed in United States 
 
318201792 (1005) Rev. A
 If the information in this manual is not followed 
exactly, a fire or explosion may result causing property damage, 
personal injury or death.
FOR YOUR SAFETY:
—  Do not store or use gasoline or other flammable vapors and 
liquids in the vicinity of this or any other appliance.
—  WHAT TO DO IF YOU SMELL GAS:
•  Do not try to light any appliance.
•  Do not touch any electrical switch; do not use any phone in 
your building.
•  Immediately call your gas supplier from a neighbor's phone.  
Follow the gas supplier's instructions.
•  If you cannot reach your gas supplier, call the fire department.
—  Installation and service must be performed by a qualified 
installer, service agency or the gas supplier.
  All appliances can tip.
• Injury to persons 
could result.
• Install anti-tip 
bracket packed with 
your appliance.
• See Installation 
Instructions.
2. Dimensions that are shown must be used. Given 
dimensions provide minimum clearance. Contact 
surface must be solid and level.
Avoid locating cabinet storage space above the 
surface burners to eliminate the possibility of cabinets 
catching on fire, or personal burns from reaching for 
the cabinets over the heated units. Avoid locating 
cabinet storage space above the surface burners. 
The absence of cabinets will eliminate the chance of 
cabinets catching on fire, and eliminate the possibility 
of receiving personal burns from reaching for the 
cabinets over flaming surface burners. If cabinet 
storage is to be provided, risk can be reduced by 
installing a range hood that projects horizontally a 
minimum of 5" beyond the bottom of the cabinets.
Note: For appliance installed in the 
State of Massachusetts see page 2.
 FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors 
and liquids in the vicinity of this or any other appliance.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.