Frigidaire FASE7073NW Manuale Proprietario

18

Before calling for service, review this list. It may save both time and expense. The list includes common occurrences 

that are not the result of defective workmanship or materials in this dryer.

OCCURRENCE

POSSIBLE CAUSE

SOLUTION

Dryer does not start.

Electrical power cord is not securely plugged in or plug 

may be loose.

Make sure the plug fi ts tightly in wall outlet.

House fuse blown or circuit breaker tripped.

Reset circuit breaker or replace fuse. 

Make sure electrical line is not overloaded and the dryer is on a 

separate circuit.

Thermal limiter tripped.

Call authorized service person for replacement.

Dryer runs but won’t 

heat.

There are 2 house fuses in the dryer circuit. If 1 of the 2 

fuses is blown, the drum may turn but the heater will not 

operate. (electric models)

Replace fuse.

Gas supply valve is not open (gas models).

Check to make sure supply valve is open. See INSTALLATION 

INSTRUCTIONS for procedure.

Dryer does not have enough air supply to support the 

burner fl ame (gas models).

See INSTALLATION INSTRUCTIONS.

LP gas supply tank is empty or there has been a utility 

interruption of natural gas (gas models).

Refi ll or replace tank.
Dryer should heat when utility service is restored.

Drying cycle takes too 

long, outside of the 

dryer feels too hot or 

smells hot.

Lint fi lter is clogged with lint.

Make sure all lint has been removed from the dryer lint fi lter 

before starting each cycle.

Exhaust duct requirements have not been met.

Exhaust duct must be at least 4 inches in diameter and made 

of rigid or semi-rigid metal.
When in place, the duct must have no more than two 90° 

bends and must not exceed length listed in INSTALLATION 

INSTRUCTIONS.

Electric dryer is connected to a 208 volt circuit.

Drying time will be 20% longer than drying on a 240 volt 

circuit.

Drying procedures have not been followed.

See “Operating Instructions.”

Outside exhaust hood or exhaust duct may be clogged 

or restricted.

Clean out any obstruction.

High humidity.

Use a dehumidifi er near the dryer.

Excessive wrinkling.

Dryer is overloaded.

Do not overload. See “Operating Instructions.”

Items left in dryer too long.

Remove items as soon as cycle ends.

Insuffi cient sorting of items.

See “Operating Instructions.”

Drying temperature too high.

Follow fabric care label instructions.

Scratching or chipping 

of the drum fi nish.

Foreign objects such as coins, pins, clips or buttons 

are inside the dryer.*

Always remove foreign objects from pockets before laundering. 

Remove objects from drum and restart dryer. 

Permanently attached items such as belt buckles, 

zippers and fasteners may be hitting the inside of the 

drum.*

It may be necessary to sew a scrap of material securely around 

ornaments before drying to prevent scratching and damage to 

the dryer.

*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.