Maytag MRT711BZDH Manuale Proprietario

1. Replace the parts for the bottom hinge as shown. Tighten 

screws.
NOTE: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets 
to hold the doors in place while you are working. 

2. Lower the bottom of the refrigerator door onto the bottom 

hinge pin. 

3. Measure the distance from the bottom of the refrigerator door 

to the floor. The distance should be approximately 3

¹⁄₂" 

(88 mm). 
NOTE: If necessary, loosen the bottom hinge without 
removing the screws, adjust the door to the correct height, 
and then fully tighten the screws.

4. Assemble the parts for the center hinge as previously shown 

and tighten all screws. See Center Hinge graphic.

1. Place washer on the upper hinge pin of the center hinge. 
2. Place the freezer door on the upper hinge pin of the center 

hinge.   

3. Insert the top hinge pin into the drilled hole in the top of the 

freezer door. Do not tighten the screws completely. 

4. Align the doors so that the bottom of the freezer door aligns 

evenly with the top of the refrigerator door. Tighten all screws.
NOTE: The distance between the doors should be 
approximately 

⁵⁄₈" (16 mm). 

1. Remove the cover from the base grille. Move cover to the 

opposite side.

2. Push the base grille toward the cabinet until it is flush. 

3. Plug in the refrigerator or reconnect the power.
4. Reset the controls. See “Using the Controls.”
5. Return all removable door parts to doors and food to 

refrigerator.

A