Maytag MSF21D4MDH Istruzione Sull'Installazione

1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See “Water and Ice Dispensers” in the 

User Instructions or User Guide.

NOTE: Allow 24 hours to produce the first batch of ice. Allow 
72 hours to completely fill ice container.

The refrigerator and freezer controls are located on the dispenser 
panel.
IMPORTANT: The display screen on the dispenser control panel 
will turn off automatically and enter “sleep” mode when the 
control buttons and dispenser lever have not been used for 
2 minutes or more. While in “sleep” mode, the first press of a 
control button will only reactivate the display screen, without 
changing any settings. 

■

Touch any control button on the dispenser panel to activate 
the display screen. The home screen will appear as shown.  

For your convenience, your refrigerator and freezer controls are 
preset at the factory. When you first install your refrigerator, make 
sure that both the refrigerator and freezer controls are still set to 
“4,” the recommended “mid-setting.” 
IMPORTANT: 

■

Wait 24 hours before you put food into the refrigerator. If you 
add food before the refrigerator has cooled completely, your 
food may spoil.

NOTE: Adjusting the set points to a colder than 
recommended setting will not cool the compartments any 
faster.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.

■

The preset settings should be correct for normal household 
usage. The controls are set correctly when milk or juice is as 
cold as you like and when ice cream is firm.

■

Wait at least 24 hours between adjustments. Recheck the 
temperatures before other adjustments are made.

When adjusting set points, use the following chart as a guide.   

The set point range is “1” (coldest) to “7” (least cold). When the 
recommended “mid-setting” (“4”) is selected, a check mark 
appears next to the setting.
Refrigerator Control: 

■

Press FRIDGE TEMP to view the current set point for the 
refrigerator. 

■

Press FRIDGE TEMP again to adjust the set point. The setting 
will decrease by 1 with each press of the button, looping back 
to “7” after reaching “1.”

After 60 seconds of inactivity, any changes will be saved and 
the display will return to the home screen.

Freezer Control: 

■

Press FREEZER TEMP to view the current set point for the 
freezer. 

REFRIGERATOR too cold

REFRIGERATOR Setting
one setting higher 

REFRIGERATOR too warm 

REFRIGERATOR Setting
one setting lower

FREEZER too cold

FREEZER Setting
one setting higher

FREEZER too warm /
Too little ice

FREEZER Setting
one setting lower