Maytag MSF21D4MDH Istruzione Sull'Installazione

■

To turn on the ice maker, lift open the ice maker door and 
lower the wire shutoff arm to the ON position.

■

To manually turn off the ice maker, lift the wire shutoff arm to 
the OFF (arm up) position and listen for the click. Ice can still 
be dispensed, but no more can be made.

NOTE: Your ice maker has an automatic shutoff. As ice is made, 
the ice cubes will fill the ice storage bin, and the ice cubes will 
raise the wire shutoff arm to the OFF (arm up) position. Do not 
force the wire shutoff arm up or down.

1. Lift and hold open the ice maker door.
2. Lift the wire shutoff arm so it clicks into the OFF (up) position. 

Release the ice maker door.

3. Lift up the front of the storage bin and pull it out. 

4. Replace the bin by pushing it in all the way, or the dispenser 

will not work. 

5. To restart ice production, lift open the ice maker door and 

push the wire shutoff arm down to the ON position.

The filter status light will help you know when to change your 
water filter. Depending on your model, the status light will appear 
as one of the following icons:       

■

The light will appear in yellow on the dispenser display screen 
when it is almost time to change the filter. 

■

It is recommended that you replace the filter when the status 
light changes to red OR water flow to your water dispenser or 
ice maker decreases noticeably. 

NOTE: The filter should be replaced at least every 6 months, 
depending on your water quality and usage.

■

After changing the filter, reset the filter status light by pressing 
FILTER RESET. 

The status light will turn off when the system is reset.

1. Locate the water filter cover door in the base grille, and pull 

open the filter door. The filter will be released and then be 
ejected as the door is opened.

2. When the door is completely open, pull the filter straight out.

NOTE: There may be some water in the filter. Some spilling 
may occur. Use a towel to wipe up any spills.

3. Take the new filter out of its packaging and remove the cap. 

Be sure the O-rings are still in place after the cap is removed. 

4. With the arrow pointing to the left (toward the filter cover 

door’s hinge), align the new filter with the filter housing and 
slide it into place. The filter cover door will automatically begin 
to close as the new filter is inserted.

5. Close the filter cover door completely in order to snap the filter 

into place. You may need to press hard.

6. Flush the water system. See “Water and Ice Dispensers.”

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.

A

B

B

A