Maytag MRT711BZDM Manuale Proprietario

Pagina di 66
7
Reverse Doors (optional)
See complete graphics later in these instructions.
Reverse Center Hinge
1. Remove the three dome caps and screws from the handle 
side and use them to fill the holes created when the hinge 
screws were removed. 
2. Using the three 
⁵⁄₁₆" hex-head hinge screws removed in 
Step 1, insert two screws halfway into the holes, leaving 
space to insert the center hinge.
3. Slide the center hinge, from the right, onto the screws, insert 
the third screw, and then tighten all screws completely.
NOTE: Make sure the washers are in place on both the top 
and bottom pins of the center hinge.    
Reverse Freezer Door 
1. Remove the three cabinet hole plugs from the top of the 
cabinet and place them in the hinge holes on the opposite 
side.
2. Remove the two screws from the bottom of the freezer door 
handle. 
3. Using the 
¹⁄₈" hex key, loosen the setscrew attaching the top of 
the handle. Then, pull the handle away from the door. 
4. Using the plastic tool (provided), remove the brand badge 
from the freezer door by prying up the right-hand side and 
slowly peeling the badge away from the door, revealing the 
hole to mount the door handle. Replace it with the badge 
provided in the Reversibility Kit located inside the crisper. For 
proper placement, see the Brand Badge Placement template 
(the last page of this manual). 
NOTES:
To avoid scratching the finish, do not use a sharp or 
metallic object to pry the brand badge from the door.
Rub a small amount of liquid dish soap over any adhesive 
residue with your fingers. Rinse the door with warm water 
and dry with a soft cloth. 
5. Remove the shoulder screw and its washer from the left-hand 
side of the door and fasten it into the hole that was behind the 
brand badge.
6. Remove the door stop from the bottom of the freezer door. 
A. Dome cap washers
B.
⁵⁄₁₆
" Hex-head hinge screws
C. Dome caps 
A.
⁵⁄₁₆
" Hex-head hinge screws
B. Washers
Door Hinge
Hole Plug
Cabinet Hinge
Hole Plug
Dome Cap
Dome Cap
Washer
Setscrew
Shoulder
Screw
Shoulder
Screw Washer
Door Stop
Screw
Flat-Head
Handle
Screw
Door Handle
Hole Plug
A
B
C
A
A
B
A. Cabinet hole plugs
A. Shoulder screw
B. Setscrew
C. Flat-head handle screws
A. Door stop screw
B. Door stop
A
B
A
C
B
A