Maytag MFX2876DRE Scheda Tecnica

Pagina di 100
25
Temperature and Moisture
 
Hissing/Dripping
Flow of refrigerant, or flow of oil in the compressor 
This is normal.
Vibration
The refrigerator may not be steady.
Adjust the leveling screws and lower the 
leveling foot firmly against the floor. See 
“Door Closing and Door Alignment.”
Rattling/Banging
Movement of the water lines against the refrigerator cabinet, 
or of items placed on top of the refrigerator cabinet
Move excess water line away from the 
refrigerator cabinet or fasten excess 
tubing to the cabinet. See “Connecting 
the Water,” or remove items from the top 
of the refrigerator.
Sizzling
Water dripping on the heater during defrost cycle
This is normal.
Water running/Gurgling
May be heard when ice melts during the defrost cycle and 
water runs into the drain pan
This is normal.
Buzzing and Clicking
Heard when the water valve opens and closes to dispense 
water and/or fill the ice maker. 
If the refrigerator is connected to a water 
line, this is normal.
If the refrigerator is not connected to a 
water line, turn OFF the ice maker.
Repetitive Clicking
Dual evaporator valve regulating the cooling operation
You may hear rapid repetitive clicking 
sounds as the unit switches from cooling 
one compartment to cooling the other. 
This sound is normal. 
Creaking/Cracking/Grinding May be heard as ice is being ejected from the ice maker 
mold.
This is normal.
Clatter
May be heard when the ice falls into the ice storage bin.
This is normal.
PROBLEM
POSSIBLE CAUSES 
SOLUTIONS
PROBLEM
POSSIBLE CAUSES 
SOLUTIONS
Temperature is too warm
The refrigerator has just been 
installed.
Allow 24 hours following installation for the refrigerator to 
cool completely.
Cooling is turned off.
Turn on cooling. See “Using the Control(s).”
The controls are not set correctly for 
the surrounding conditions.
Adjust the controls a setting colder. Check the temperature in 
24 hours. See “Using the Control(s).”
The door(s) are opened often or not 
closed completely.
Allows warm air to enter refrigerator. Minimize door openings 
and keep doors fully closed.
A large load of food was recently 
added.
Allow several hours for refrigerator to return to normal 
temperature.
Temperature is too cold in 
the refrigerator/crisper
The refrigerator air vent(s) are blocked. If the air vent located in the top, left, rear corner of the 
refrigerator compartment is blocked by items placed directly 
in front of it, the refrigerator will get too cold. Move items 
away from the air vent.
The controls are not set correctly for 
the surrounding conditions.
Adjust the controls a setting warmer. Check the temperature 
in 24 hours. See “Using the Control(s).”
The ice storage bin is not in the 
correct position. 
See “Ice Maker and Ice Storage Bin.”
Temperature is too cold in 
the pantry drawers
The control is not set correctly for the 
items stored in drawer.
Adjust the temperature setting. See “Temperature Controlled 
Drawer” in the “Refrigerator Features” section.