Maytag MSF22D4XAW Scheda Tecnica
19
ACCESSORIES
The following accessories are available for your refrigerator.
To order an accessory, call 1-800-688-9900 and ask for the
appropriate part number listed below or contact your authorized
MAYTAG
To order an accessory, call 1-800-688-9900 and ask for the
appropriate part number listed below or contact your authorized
MAYTAG
®
Appliances dealer. In Canada, call 1-800-807-6777.
affresh™
†
Stainless Steel Cleaner:
Order Part #W10355016
In Canada, order Part #W10355016B
In Canada, order Part #W10355016B
affresh™
†
Stainless Steel Wipes:
Order Part #W10355049
In Canada, order Part #W10355049B
In Canada, order Part #W10355049B
affresh™
†
Kitchen & Appliance Cleaner:
Order Part #W10355010
In Canada, order Part #W10355010B
In Canada, order Part #W10355010B
Water Filter:
Order Part #W10295370 (P4RFWB)
Order Part #W10295370 (P4RFWB)
WATER FILTER CERTIFICATIONS
Water is leaking
or dripping
from the
dispenser
or dripping
from the
dispenser
NOTE: After dispensing, a few additional drops of water are normal.
■
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
2 to 3 seconds after releasing the dispenser pad/lever.
2 to 3 seconds after releasing the dispenser pad/lever.
■
New installation, or water filter was recently installed or replaced - Air in the water lines causes the water
dispenser to drip. Flush the water system to remove the air in the water lines. See “Water and Ice
Dispensers.”
dispenser to drip. Flush the water system to remove the air in the water lines. See “Water and Ice
Dispensers.”
■
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces.
Water is leaking
from the back
of the refrigerator
from the back
of the refrigerator
■
Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
“Connect Water Supply.”
“Connect Water Supply.”
Water from the
dispenser is not
cool enough
(on some models)
dispenser is not
cool enough
(on some models)
NOTE: Water from the dispenser is chilled to 50°F (10°C).
■
New installation - Allow 24 hours after installation for the water supply to cool completely.
■
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool completely.
■
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first glass of
water dispensed.
water dispensed.
■
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold
water pipe. See “Water Supply Requirements.”
water pipe. See “Water Supply Requirements.”
ICE AND WATER Possible Causes and/or Recommended Solutions
†™ AFFRESH is a trademark of Whirlpool, U.S.A.