Thunderdog B103 Manuale Proprietario

B103

Before  using  this  product,  fully  charge  the 

B103  headset  unit  by 

plugging the charger into an AC outlet and inserting the connection pin 

into the Charging Port on the headset.

1. Turn your phone OFF entirely and then turn it back ON to refresh its Bluetooth memory.

2. Find the Bluetooth menu in your mobile phone turn the Bluetooth function ON.(Check your mobile phone user guide)

 

4. On your phone, perform a Bluetooth “device discovery” to add the B103 headset as a new device. It only takes a few seconds to search  

& find the 

B103 Bluetooth headset.

5. When the B103 headset is discovered (found) the phone will display “B103”

6. If prompted by your phone to enter a code, enter; "0000" and the phone will now pair with the headset and be ready to use.

7. If supported by your phone menu, set the  B103 as "set as authorized "or "add to trusted devices".

8. Keep the Bluetooth function on your phone ON with your phone near, the headset will automatically pair.

9. If the pairing is not successful, the headset will shortly return to the standby mode.. Please repeat the process to try the pairing again.

10. Refer to your phones User Manual for any additional steps.

Note: To conserve power, the unit automatically turns off when not paired with your Bluetooth Phone.

Press the 

FUNCTION button twice. 

3. With the B103  POWER OFF hold the headset 12” inches away from your mobile phone and Press and Hold the  FUNCTION  button 

  on the headset for about 6 seconds until the LED light flashes blue and red alternating which indicates your headset is in 

  and is now ready to be “paired” with your Bluetooth Mobile Phone.      

Press the 

FUNCTION button once when there is an incoming call to answer.  Press the FUNCTION button once again to end the call. 

Press and Hold the the 

FUNCTION button (approx. 2-3 seconds) when there is an incoming call you want to ignore and send it to your voicemail. 

While connected to your phone, Press and hold the 

FUNCTION button (approx. 2-3 seconds) until you hear two beeps.  

Voice commands must already be recorded into your phone for this function to operate (see your phones user guide)

Click the 

VOLUME UP or VOLUME DOWN button during a call to adjust to the desired level.  The volume level will be remembered by the 

B103 for the next call. 

* To use these functions, your phone/device must also support the Bluetooth Profile.

Press and Hold the 

FUNCTION button (approx. 2-3 seconds) until the blue 

Press and Hold the 

FUNCTION button (approx. 2-3 seconds) until the 

red indicator flashes twice and the power will turn off. 

indicator flashes four times.

11. To pair a second phone, turn the headset OFF and repeat steps 3-10.

The headset will cycle through available language options.  Press the 

button to confirm your language choice.

Press and Hold the 

FUNCTION button for about 6 seconds until the LED light flashes blue & red alternating. Now Press and hold the 

FUNCTION button until you hear a beep.