Summit 33-Bottle Built-in Undercounter Wine Cooler Manuale Utente
6
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 9.)
• Install the handle on the door. (See page 9.)
INSTALLATION OF YOUR APPLIANCE
• The appliance is designed for built-in, recessed or free-standing installation.
• The appliance is designed for built-in, recessed or free-standing installation.
• WARNING: Do not store or install the appliance outdoors.
• CAUTION
• CAUTION
:
This appliance is designed for storing and cooling wines. Do not store perishable food,
medicine or other medical products.
• Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front adjustable legs.
• For freestanding installation, 5 inches (127mm) of space between the back and sides of the unit are
suggested, which allows the proper air circulation to cool the compressor and condenser for energy
saving. Even for built-in installation, you should provide the following clearances to ensure the best
operation and proper ventilation: 3/16” on both sides, 2” at the rear and 1/16” at the top. Take care that
the air vent at the front of the appliance is never covered or blocked in any way.
saving. Even for built-in installation, you should provide the following clearances to ensure the best
operation and proper ventilation: 3/16” on both sides, 2” at the rear and 1/16” at the top. Take care that
the air vent at the front of the appliance is never covered or blocked in any way.
• NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the Wine Cellar into an exclusive, properly grounded wall outlet. Do not under any circum-
• Plug the Wine Cellar into an exclusive, properly grounded wall outlet. Do not under any circum-
stances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized service center.
and/or grounding should be directed toward a certified electrician or an authorized service center.
BUILT-IN CABINET INSTRUCTIONS
This unit is designed for either built-in or free-standing installation. If you plan to use the unit in a built-in
application, use the following dimensions for the enclosure:
Model
SWC1535B
SWC1875B
Width
15” / 38 cm
23
⅝” / 60 cm
Depth
23
¼
” / 59 cm
23
¼
” / 59 cm
Height
34
¼
” / 87 cm
69
⅞
” / 177.5 cm
ELECTRICAL CONNECTION
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
damaged, have it replaced by a qualified electrician or an authorized service center.