BSG SaniClean Low-Foaming Acid-Based Sanitizer - 16 oz Scheda Tecnica
PAGE 2
SANICLEAN
INGESTION:
If conscious, give several glasses of milk, water, egg whites or gelatin solution. Get
medical attention immediately. DO NOT induce vomiting.
medical attention immediately. DO NOT induce vomiting.
INHALATION:
Move victim to fresh air. Call emergency medical care. Apply
artificial respiration if victim is not breathing.
NOTE TO
PHYSICIAN:
PHYSICIAN:
Probable mucosal damage may contraindicate the use of gastric lavage. Measures against
circulatory shock, respiratory depression and convulsion may be needed.
circulatory shock, respiratory depression and convulsion may be needed.
____________________________________________________________________________________________
SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION:
Atmospheric levels should be maintained below the exposure limits
Listed in Hazardous Ingredients by using engineering controls. If not feasible,
Use approved full-face piece air-purifying respirator.
VENTILATION SYSTEM:
Provide general and/or local exhaust ventilation to maintain airborne
levels below the exposure limits in Hazardous Ingredients. Refer to “Industrial
Ventilation” by ACGIH for a manual of recommended practices.
levels below the exposure limits in Hazardous Ingredients. Refer to “Industrial
Ventilation” by ACGIH for a manual of recommended practices.
SKIN PROTECTION:
If skin or contamination of clothing is likely, protective clothing should be worn.
EYE PROTECTION:
Chemical goggles are required.
PROTECTIVE GLOVES:
Wear chemical resistant gloves.
____________________________________________________________________________________________
REACTIVITY DATA
INCOMPATIBLE MATERIALS:
Alkalis, chlorinated products, and soft metals
STABILITY:
Product is stable.
POLYMERIZATION:
Will not occur.
DECOMPOSITION PRODUCTS:
May give off phosphorous and nitrous oxide at high heat (fire
conditions).
conditions).
____________________________________________________________________________________________
SPILL OR LEAK PROCEDURES
SPILL:
See Emergency/ First Aid Procedures and Special Protection Information for hazards and
exposure controls. Dike with sand or earth to contain spill. Avoid ignition sources.
Absorb with sand to other non-flammable material and transfer to approve DOT drum for
recovery or disposal.
exposure controls. Dike with sand or earth to contain spill. Avoid ignition sources.
Absorb with sand to other non-flammable material and transfer to approve DOT drum for
recovery or disposal.
DISPOSAL:
Dispose of in accordance with local, state and federal regulations.
GENERAL:
CERCLA/SARA requires notification to the appropriate Federal state and local
authorities of releases of hazardous or extremely hazardous quantities equal to or greater
than the Reportable Quantities (RQs) in 50 CFR 302.4 and 40 CFR 355.
SARA Title 313 requires submissions of annual reports of releases of toxic chemicals
that appear in 40 CFR 372. Components present in this product at a level which could
require reporting under statute are listed under identification.
authorities of releases of hazardous or extremely hazardous quantities equal to or greater
than the Reportable Quantities (RQs) in 50 CFR 302.4 and 40 CFR 355.
SARA Title 313 requires submissions of annual reports of releases of toxic chemicals
that appear in 40 CFR 372. Components present in this product at a level which could
require reporting under statute are listed under identification.
__________________________________________________________________________________________
TRANSPORTATION
DOT HAZARD CLASSIFICATION:
Corrosive Liquids, N.O.S.
8, UN1760, PG III
PLACARD REQUIRED:
Corrosive, UN1760, Class 8
LABEL REQUIRED:
Corrosive, Class 8, Label required by OSHA Hazard Communication
Standard, and any applicable state and local regulations.
Standard, and any applicable state and local regulations.
__________________________________________________________________________________________
EMERGENCY TELEPHONE: INFOTRAC 800-535-5053