Marvel Dual Zone Wine Cellar - Black Cabinet with Black Wide Trim Glass Door Manuale Utente

Door Ajar

ALARM RESET

Power Failure

ALARM RESET

Temp

NOTE

Door Ajar

Temp

Temperature mode (Single and Dual Zone):

The temperature mode is preset from the factory in Fahren-

heit (°F) but you have the option to change it to Centigrade

(°C). To change the mode, press and hold the "-" keypad,

while pressing the "+" keypad, then release the "-" keypad.

The temperature will now be displayed in Centigrade (°C).

Repeat the procedure to change the temperature mode

back to Fahrenheit (°F).

• Power failure -

If power to the appliance is inter-

rupted the System Status indicator will turn-off and

the "Power Failure" indicator will flash. Additionally, an

"ALARM RESET" indicator will be displayed below the

"On/Off" keypad. No audible tone will sound. This alarm

condition can be reset by momentarily pressing the

"On/Off" keypad. If this alarm occurs, it is recommend-

ed that you check the condition of any perishables,

even if the appliance is operating normally and the tem-

perature has recovered, as prolonged power outages

could result in excessive temperature excursions which

may spoil perishables.

• Temperature alarm -

If the storage compartment

temperature exceeds 10°F from set-point for more than

a 1-hour duration, the System Status indicator will turn

off, the "Temp" indicator will flash, and an audible tone

will sound every 60-seconds. Additionally, an "ALARM

RESET" indicator will be displayed below the "On/Off"

keypad. This alarm condition can be reset by momen-

tarily pressing the "On/Off" keypad. If this alarm occurs

it is recommended that you check the condition of your

stored contents, even though the appliance is operating

normally and the temperature has recovered, as pro-

longed temperature excursions could spoil perishables.

Multiple alarms are possible, i.e.- "Door Ajar" for a pro-

longed period may trigger a "Temp" alarm, in which case

both "Door Ajar" and "Temp" indicators will activate.

USING YOUR ELECTRONIC CONTROL

Control lock (Single and Dual Zone):

The control panel can be locked to avoid unintentional

changes. To lock the control, press and hold the "Lock" key-

pad until the display reads "Loc" then release your finger

from the keypad. The lock icon will flash 3-times and then

continuously illuminate. When the control panel is locked,

only the Lock keypad, System Status OK indicator , and

the Alarm indicator are active. To un-lock the control panel,

repeat this instruction until the display reads "nLc".

Alarms (Single and Dual Zone):

The control will alert you to conditions that could adversely

affect the performance of the appliance.

• Door ajar -

If the door is open, or not closed prop-

erly, for more than 5-minutes the System Status OK

indicator will turn-off, the "Door Ajar" indicator will flash,

and a tone will sound every 60 seconds. Additionally,

an "ALARM RESET" indicator will be displayed below

the "On/Off" keypad. This alarm condition can be reset

by closing the door or momentarily pressing the "On/

Off" keypad, (i.e.-if you are cleaning the storage com-

partment, etc.). The alarm will recur in 5-minutes if the

alarm condition persists.