U-Line 1000 Series Frost-Free Refrigerator / Freezer - Black Cabinet with White Door Manuale Utente

USER GUIDE

 Troubleshooting 2

u-line.com

SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

1. Partially fill a plastic (nonbreakable) bottle with water. 

2. Insert an accurate thermometer. 

3. Tighten the bottle cap securely.

4. Place the bottle in the desired area for 24 hours. 

5. Avoid opening the unit during the testing period. 

6. After 24 hours, check the temperature of the water. If 

required, adjust the temperature control in a small 
increment (see CONTROL OPERATION). 

• Temperature setting.

• Ambient temperature where installed.

• Installation in direct sunlight or near a heat source.

• The number of door openings and the time the door is 

open.

• The time the internal light is illuminated. (This mainly 

affects product on the top rack or shelf.)

• Obstruction of front grille or condenser.

Digital Display 

Shows 1-16 or 

99

A factory test mode may be enabled. Adjust 

the temperature to 99 and press the light icon.

Product Is 

Freezing.

Because product in contact with the rear wall 

may freeze, ensure no product is touching the 

rear wall.
Adjust the temperature to a warmer set point. 

Product Is Not 

Cold Enough.

Air temperature does not indicate product 

temperature. See CHECKING PRODUCT 

TEMPERATURE below.
Adjust the temperature to a cooler set point.
Ensure unit is not located in excessive ambient 

temperatures or in direct sunlight.
Ensure the door is closing and sealing 

properly.
Ensure the interior light has not remained on 

too long.
Ensure nothing is blocking the front grille, 

found at the bottom of the unit.
Ensure the condenser coil is clean and free of 

any dirt or lint build-up.