Philips PTA02/00 Manuale Utente
2
Welcome to the exciting world of 3D TV at
home!
Installation
What’s in the box
- 2x Active 3D glasses
- 2x microfiber pouch
- a range of 3 nose bridge pieces for each pair
of glasses
- 3D transmitter
- USB device with a TV software update
Prepare the 3D glasses
1 Pull and remove the plastic strip to activate
the battery inside. Or alternatively open the small
battery cover of the 3D glasses and insert the
battery - type CR2032.
2 Mount the nose bridge on the glasses that fits
you best.
Installation
1 Switch off the TV.
2 Connect the 3D transmitter to the 3D con-
nection 3D Out on the back of the TV.
3 Install the 3D transmitter on the top or at
the bottom of the TV. Make sure to point the
transmitter directly to where you sit to watch TV.
The small window in the middle of the glasses
receives the 3D signals from the transmitter.
Update the TV software
To prepare your TV for 3D watching, you must
update the TV software.
1 Switch on the TV.
2 Plug in the USB device in the USB connection
at the side of the TV.
3 The software update will start automatically
and during the update the TV might switch off
and on again. Do not press any key on the
remote control and wait until the message
‘Operation Successful’ appears.
4 Unplug the USB device and switch the TV off
and back on again.
Your TV is ready to watch 3D.
USB
PTA02
292892_Brochure_3D.indd 2
31-05-2010 18:56:28